| 喷油嘴结构对尾喷雾化质量影响的研究 |
| |
| 引用本文： | 杜慧勇,李民,刘建新,宗永平.喷油嘴结构对尾喷雾化质量影响的研究[J].拖拉机与农用运输车,2006,33(5):48-49. |
| |
| 作者姓名： | 杜慧勇 李民 刘建新 宗永平 |
| |
| 作者单位： | 河南科技大学,车辆与动力工程学院,河南,洛阳,471003 |
| |
| 基金项目： | 河南省青年骨干教师资助计划项目，河南科技大学基金项目(20020009) |
| |
| 摘 要： | 利用高速频闪照相系统研究了不同的喷油嘴结构参数对燃油尾喷雾化质量的影响。试验结果表明,喷油嘴压力室容积是影响尾喷雾化质量的关键因素。传统的有压力室喷油嘴在尾喷后期有少量燃油以较低的速度呈液滴状流出喷孔,完全没有雾化;而对于无压力室喷油嘴,针阀落座时燃油喷射过程能迅速停止,未出现尾喷后期雾化质量不良的现象。据此推论,无压力室喷油嘴使柴油机HC排放降低的一个重要原因是消除或减轻了有压力室喷油嘴所存在的尾喷雾化质量不良现象。
|
| 关 键 词： | 柴油机 喷油嘴 压力室 喷雾 |
| 文章编号： | 1006-0006(2006)05-0048-02 |
| 收稿时间： | 2005-12-22 |
| 修稿时间： | 2005年12月22 |
Effects of Nozzle Structure on Spray Atomization at End of Injection |
| |
| DU Hui-yong,LI Min,LIU Jian-xin,ZONG Yong-ping.Effects of Nozzle Structure on Spray Atomization at End of Injection[J].Tractor & Farm Transporter,2006,33(5):48-49. |
| |
| Authors: | DU Hui-yong LI Min LIU Jian-xin ZONG Yong-ping |
| |
| Institution: | School of Vehicle and Power Engineering, Henan University of Science and Technology, Luoyang 471003, China |
| |
| Abstract: | By using high speed camera,the effects of nozzle structure on the spray atomization at the end of(injection) are investigated in this paper.The experimental results show that,after injection of a sac nozzle,there is still a little of fuel flow from orifices as liquid in a very low speed without atomization.On the contrary,the fuel injection process stops(immediately) right after the valve covers orifices,and there is no more liquid fuel flowing out.Spray atomization at the end of injection is one of the key factors about why the HC emission from a diesel engine as using VCO nozzle is much lower than that using normal sac nozzle. |
| |
| Keywords: | Diesel engine Nozzle Sac Spray |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
