不同施氮量下覆膜滴灌玉米相对根长密度模型研究

为探明施氮量对宁夏引黄灌区覆膜滴灌玉米根长密度(RLD)的影响,设置5个施氮水平和1个对照(CK,不施氮与不覆膜)进行试验,测定玉米RLD,建立不同施氮量下相对根长密度(NRLD)模型,并加以检验。结果表明:不同施氮处理的玉米RLD分布区域均随土层深度的增加而减小,且大部分集中在0～20 cm土层;随着施氮量的增加,RLD分布区域明显扩大; NRLD分布满足三阶多项式函数模型,模拟曲线的决定系数R2为0.951,模型检验结果R2为0.845,均方根误差(RMSE)为0.248,拟合效果好,但该多项式模型不能保证NRLD在相对取样深度Zr为1时达到0,故对玉米NRLD分布多项式模型进行优化。优化模型验证结果显示,各施氮处理RMSE不大于0.308,CK、N0、N1、N2、N3和N4处理的标准化均方根误差分别为0.242、0.193、0.184、0.226、0.208和0.273,R2分别为0.903、0.953、0.920、0.944、0.962和0.898,具有较高的拟合度,解决了NRLD在Zr=1时达到0的问题。本研究可为宁夏引黄灌区膜下滴灌玉米NRLD分布拟合、根系养分吸收和施肥管理提供理论参考。     

高效预应力混凝土框架的试验研究

通过２榀预应力混凝土叠合框架１：３比例的模型试验，了解了叠合梁框架在竖向荷载作用下的受力性能。讨论了叠合梁截面应变分布特点，并分析了梁的配筋率这一主要参数对框架极限承载力和破坏形态的影响。     

两种塑料暖棚猪舍的应用效果观测

在青海省乌兰县舍外温度－6．30℃条件下，选用40头荣昌猪分作2组，每组20头，在自行设计的半开放－封闭式多用塑料暖棚猪舍与常用简易塑料暖棚猪舍内开展对比试验。结果表明，前者可显著提高舍内温度，降低舍内湿度，且育猪增重效果明显。     

不同条件下蒙古冰草种子产量及产量构成因子的分析

在西苏旗对蒙古冰草的种子产量及产量构成因子进行了分析得出结果为冰草的实际种子产量与潜在种子产量差别很大，蒙古冰草种子产量的主要限制因子为抽穗率和结实率。     

Deep Freezing of Boar Semen Packaged in Plastic Bags and Straws

For practical reasons, a large volume (i.e. 5 ml) of frozen boar semen per insemination dose is desirable, but successful freezing has not been achieved, since optimal cooling rates have not yet been established. Post-thaw motility and the acrosome intep'ty of semen from four boars frozen with a programmable freezin machine, in mini-(0.25 ml), maxi-(5 ml) plastic straws and in 10 × 5 cm PVC- or Teflon FEP-plastic bags (0.35 – 0.12 mm thick, 5 ml) was studied. The freezing of the semen was monitored using thermocouples placed in the straws and the bags. The freezing curve started from +5°C, at a rate of −3°C/min, to – 6°C, it was held for 1 min at −6°C, and was followed by further drop to −100°C at a rate of −20°C/min, with subsequent storage in LN₂. The bags had a much shorter freezing point plnteau, compared to the maxi-straws. Post-thaw sperm motility was significantly higher when semen was frozen in mini-straws or in bags than in maxi-straws. The freezing procedure did not cause major acrosomal damages, significantly more normal apical ridges being present in the bags and mini-straws than in the maxi-straws. This in vitro evaluation indicates that the freezing method employed is satisfactory for freezing large volumes of boar semen into plastic bags .     

LLDPE/PS塑料合金及其与木纤维形成复合材料的研究

研究线性低密度聚乙烯(LLDPE)与聚苯乙烯(PS)共混制备的塑料合金的性能并用不同制备条件的塑料合金与木纤维复合形成塑料合金/木纤维复合材料,研究该种复合材料的外观质量及物理力学性能.结果表明:不同共混比例与共混温度对制备的塑料合金熔体流动性、力学强度有较显著影响.塑料合金/木纤维复合材料的性能与塑料合金共混比例及共混温度有较强的相关性.2种塑料在共混比为50/50,共混温度为200℃时,形成的塑料合金与木纤维具有相对最好的相容性和最好的材料外观质量与力学性能.DMA试验表明:塑料合金/木纤维复合材料的耐热性明显优于相应的塑料合金.     

‘丰香’草莓叶片高效再生体系的建立

 以草莓主栽品种丰香( Fragaria ×ananassa Duch ‘Toyonoka’) 叶片为外植体, 研究了影响组织培养的多个因素, 建立了高效再生体系。结果表明: MS + TDZ 1.5 mg·L ^{- 1} + IBA 0.4 mg·L ^{- 1}培养基最适于不定芽分化。不同滤光膜(绿膜、红膜、蓝膜、黄膜) 对草莓不定芽的分化具显著效应, 绿膜和红膜对芽的分化有明显促进作用, 不定芽再生率达95%以上, 平均每个外植体再生芽数在25个以上; 而蓝膜和黄膜则不利于芽的分化。不同滤光膜光谱差异主要集中在300～700 nm, 红、绿膜在该波段光强较弱,而黄、蓝膜和荧光灯较强。暗处理4周比1、2、3周更有利于提高叶片的不定芽再生率, 此后转到光下培养, 获得的不定芽再生率可达100%。     

苹果低氧气调新组合贮后效应的利用研究

利用0.12mm聚乙烯薄膜大帐进行低氧气调新组合的较大规模应用试验,对2394kg玫瑰红苹果进行低氧处理,帐内O2浓度可下调至约2%,CO2浓度可自动维持在5%～8%的较理想状态,处理结束后很易转为MA自发气调。低氧处理后再MA贮藏的苹果,虎皮病果率低、症状轻,腐烂果少,果柄和果皮新鲜,叶绿素保持效果好,果肉硬度明显高于小包装气调和冷藏对照。说明利用塑膜大帐进行前期低氧新组合处理与后期自发气调、实现低氧气调新组合贮后效应的利用是可行的。     

Response of labile organic C and N pools to plastic film removal from semiarid farmland soil

To examine the effects of plastic film removal on grain yield and soil organic matter (SOM), a spring maize (Zea may L.) field experiment was conducted for 5 yr at Changwu Agricultural and Ecological Experimental Station of Northwest China. Compared with traditional plastic film mulching during entire growing stages (FM), plastic film removal at the silking stage (RM) resulted in a 6.3% higher average maize yield. Under the RM treatment, soil organic carbon and total nitrogen significantly increased after the 5‐yr cultivation in the 0‐ to 20‐cm layer. Significant increases in extractable organic C (EOC), KMnO₄‐oxidizable C (KMnO₄‐C) and C management index (CMI) in the 0‐ to 20‐cm layer, and light fraction organic C and EOC in the 20‐ to 40‐cm layer were observed in response to plastic film removal after the 1‐yr treatment; the responses were more significant after 5 yr. Under the RM treatment, significant increases in microbial biomass C, light fraction organic N, extractable organic N, KMnO₄‐C and CMI were also observed after five years in the 20‐ to 40‐cm layer. Moreover, KMnO₄‐C and EOC were much more sensitive than other labile SOM fractions to the application of RM, even after only 1 yr of cultivation. Therefore, compared with mulching for the whole growing season, plastic film removal at the maize silking stage is an effective option for increasing yields and enhancing SOM concentration and soil sustainability in the regions with semiarid monsoon climates that have sufficient rainfall during maize reproductive stages.     

粉条加工中添加石蜡的检测技术研究

【目的】探讨粉条加工过程中非法添加石蜡的测定方法,为食品监管提供保障。【方法】先以石蜡成品摸索石蜡测定的气相色谱质谱条件,再以石蜡成分C18H38和C24H50进行回收率和相对标准偏差试验。【结果】不同预处理方法中,超声萃取处理的C18H38和C24H50在粉条中的萃取回收率最高,分别为93.5%和91.0%;20min超声时间萃取粉条中烷烃成分较为适宜;所建立的粉条中石蜡含量测定方法的相对标准偏差为3.6～4.8,样品回收率均大于90.0%,达到定量检测要求。【结论】所建立的石蜡检测方法操作简单,测定结果准确可靠,可用于粉条中石蜡成分的定性及定量测定。