Variation in fibre properties of cultivated Siberian larch (<Emphasis Type="Italic">Larix sibirica</Emphasis> Ledeb.) in relation to radial and axial locations in the trunk

Introduction  

As the major resources of Siberian larch planted in Finland will be at a harvestable age in the near future, knowledge concerning wood and fibre properties of cultivated larches is needed. The properties affect both the character of pulp and paper, as well as properties important in the structural usage.     

Utilization Potential of Peats – a Study on Peat Biodegradability Determined by Respirometric Method

The biodegradation of different peat types was studied with a manometric respirometric test. Compaction peat and sphagnum peat samples were analysed, and the effect of peat pH on biodegradation behaviour was evaluated. Only minor (BOD/ThOD?<?0.4%) biodegradation was observed with compaction peat samples, and the stable state, in which biodegradation stopped, was achieved during a two month period. As expected, sphagnum peat samples with a lower decomposition rate degraded more than compaction peat samples. Alkalinity (pH between ca. 4–9) of the peat was noticed to reduce the degree of biodegradation and accelerate the achievement of the stable state.     

Elevated temperature and CO(2) concentration effects on xylem anatomy of Scots pine

We studied the effects of elevated temperature and carbon dioxide concentration ([CO(2)]) alone and together on wood anatomy of 20-year-old Scots pine (Pinus sylvestris L.) trees. The study was conducted in 16 closed chambers, providing a factorial combination of two temperature regimes and two CO(2) concentrations (ambient and elevated), with four trees in each treatment. The climate scenario included a doubling of [CO(2)] and a corresponding increase of 2-6 degrees C in temperature at the site depending on the season. Anatomical characteristics analyzed were annual earlywood, latewood and ring widths, intra-ring wood densities (earlywood, latewood and mean wood density), tracheid width, length, wall thickness, lumen diameter, wall thickness:lumen diameter ratio and mass per unit length (coarseness), and numbers of rays, resin canals and tracheids per xylem cross-sectional area. Elevated [CO(2)] increased ring width in four of six treatment years; earlywood width increased in the first two years and latewood width in the third year. Tracheid walls in both the earlywood and latewood tended to become thicker over the 6-year treatment period when temperature or [CO(2)] was elevated alone, whereas in the combined treatment they tended to become thinner relative to the tracheids of trees grown under ambient conditions. Latewood tracheid lumen diameters were larger in all the treatments relative to ambient conditions over the 6-year period, whereas lumen diameters in earlywood increased only in response to elevated [CO(2)] and were 3-6% smaller in the treatments with elevated temperature than in ambient conditions. Tracheid width, length and coarseness were greater in trees grown in elevated than in ambient temperature. The number of resin canals per mm(2) decreased in the elevated [CO(2)] treatment and increased in the elevated temperature treatments relative to ambient conditions. The treatments decreased the number of rays and tracheids per mm(2) of cross-sectional area, the greatest decrease occurring in the elevated [CO(2)] treatment. It seemed that xylem anatomy was affected more by elevated temperature than by elevated [CO(2)] and that the effects of temperature were confined to the earlywood.     

Fate of the herbicides glyphosate, glufosinate-ammonium, phenmedipham, ethofumesate and metamitron in two Finnish arable soils

The fate of five herbicides (glyphosate, glufosinate-ammonium, phenmedipham, ethofumesate and metamitron) was studied in two Finnish sugar beet fields for 26 months. Soil types were sandy loam and clay. Two different herbicide-tolerant sugar beet cultivars and three different herbicide application schedules were used. Meteorological data were collected throughout the study and soil properties were thoroughly analysed. An extensive data set of herbicide residue concentrations in soil was collected. Five different soil depths were sampled. The study was carried out using common Finnish agricultural practices and represents typical sugar beet cultivation conditions in Finland. The overall observed order of persistence was ethofumesate > glyphosate > phenmedipham > metamitron > glufosinate-ammonium. Only ethofumesate and glyphosate persisted until the subsequent spring. Seasonal variation in herbicide dissipation was very high and dissipation ceased almost completely during winter. During the 2 year experiment no indication of potential groundwater pollution risk was obtained, but herbicides may cause surface water pollution.     

Spectral image database for observing the quality of Nordic sawn timbers

In this study, a comprehensive spectral image database of Nordic sawn timbers for public use was measured. Economically significant Finnish wood species birch (Betula sp.), Norway spruce (Picea abies) and Scots pine (Pinus sylvestris) were chosen for inclusion in the database. The total of samples was 107 containing heartwood, sapwood, decayed wood, blue stain, mold, resin, early wood, late wood, knots, cracks, pith, reaction wood and bark. Board and crosscut samples were measured in frozen, melted and room-dried conditions. The reflectance of samples was measured over a 300- to 2,500-nm wavelength range. Additionally, the photoluminescence of samples excited by an ultraviolet B light source was measured. The spot size used was 250 μm with an 80 mm \(\times \) 200 mm imaging area, and produced all in all 44 million spectra. In this paper, examples of the possibilities of this spectral image database as a means of detection of the spatial distribution of aromatic lignin and the moisture content (MC) of nonfrozen timber were introduced and provided. From the results, it was found that it was possible to detect the lignin distribution from spectral images, and simple and robust methods for wood MC estimations were also introduced.     

Bacterial ghost technology for pesticide delivery

Bacterial ghosts are nondenaturated empty cell envelopes of Gram-negative bacteria produced by E-mediated lysis. Such envelopes from the plant-adhering bacterium Pectobacterium cypripedii were tested for their ability to adhere to plant material and to be used as carriers for pesticide delivery. We show, using fluorescence-labeled P. cypripedii ghosts, that depending on the target plants 55 or 10% (rice or soya, respectively) of the applied bacterial ghosts was retained on the leaves after heavy simulated rain (84 mm). Furthermore, the bacterial ghosts could be loaded with the lipophilic triazole fungicide tebuconazole. In subsequent plant experiments in the glass house, the efficacy of the loaded bacterial ghost for resistance to rainfall and the protective and curative effects against the pathogens Erysiphe graminis, Leptosphaeria nodorum, and Pyrenophora teres on barley and wheat and against Sphaerotheca fuliginea on cucumber were tested. The bacterial ghosts were compared primarily with a commercial tebuconazole formulation, a wettable powder, as it has similar physical characteristics. The comparison revealed similar effects and showed consistently higher or comparable efficacy against the pathogens. The standard operational comparison with the most protective, cereal specific emulsion of oil in water displayed that the bacterial ghosts had equal to or lower efficacy than the emulsion. This study confirmed the potential of bacterial ghost platform technology as a new alternative carrier system for pesticides.     

Structural characterization of oligosaccharides and polysaccharides from apple juices produced by enzymatic pomace liquefaction

Eight apple pomace liquefaction juices were produced to characterize soluble cell wall material released by the action of pectolytic and cellulolytic enzyme preparations. Very high colloid values from 9.7 to 19.6 g/L were recovered from the juices by ethanol precipitation. The crude polysaccharides consisted mainly of galacturonic acid (49-64 mol %), arabinose (14-23 mol %), galactose (6-15 mol %), and minor amounts of rhamnose, xylose, and glucose. Separation of the polysaccharides by anion-exchange chromatography yielded one neutral, one slightly acidic, and one acidic polymer accounting for 60% of total colloids. Preparative size exclusion chromatography of the acidic fractions resulted in four polymers of different molecular weights and different sugar compositions. Among them, high molecular weight arabinans and rhamnogalacturonans as well as oligomeric fractions consisting of only galacturonic acid could be found. Linkage studies were performed on neutral fractions from anion-exchange chromatography and size exclusion chromatography. They revealed highly branched arabinans, xyloglucans, and mainly type I arabinogalactans.     

Importance of dose metrics for lethal and sublethal sediment metal toxicity in the oligochaete worm Lumbriculus variegatus

Background, Aims, and Scope  There is an increasing demand for controlled toxicity tests to predict biological effects related to sediment metal contamination. In this context, questions of metal-specific factors, sensitivity of toxicity endpoints, and variability in exposure duration arise. In addition, the choice of the dose metrics for responses is equally important and is related to the applicability of the concept of critical body residue (CBR) in exposure assessments, as well as being the main focus of this study. Methods  Experiments were conducted to assess toxicity of Cd, Cr, Cu and Pb to the oligochaete worm Lumbriculus variegatus with the aim of determining CBRs for two response metrics. Mortality and feeding activity of worms exposed to sediment-spiked metals were used as end-points in connection with residue analyses from both the organisms and the surrounding media. Results  LC50 values were 0.3, 1.4, 5.2, and 6.7 mg/L (from 4.7 μmol/L to 128.0 μmol/L), and the order of toxicity, from most toxic to least toxic, was Cu > Cd > Pb>Cr. By relating toxicity to body residue, variability in toxicity among the metals decreased and the order of toxicity was altered. The highest lethal residue value was obtained for Cu (10.8 mmol/kg) and the lowest was obtained for Cd (2.3 mmol/kg). In the 10-d sublethal test, both time and metal exposure were an important source of variation in the feeding activity of worms. The significant treatment effects were observed from worms exposed to Cd or Pb, with the controls yielding the highest feeding rate. However, quantitative changes in the measured endpoint did not correlate with the exposure concentrations or body residues, which remained an order of magnitude lower than in the acute exposures. Discussion  Both response metrics were able to detect a toxic effect of the metals. However, the ranking of metal toxicity was dependant on the choice of the dose metric used. An attempt to form a causal mortality-mediated link between tissue residues and metal toxicity was successful in water-only exposures. The results also indicated that egestion rate was a sensitive toxicity end point for predicting the effects of sediment contamination. Conclusions  By relating the biological response with the tissue metal residues, toxicity data was comparable to both environmental media as well as different response metrics and time scales. The results also revealed the importance of metal toxicity ranking on a molar basis and, furthermore, a direct link to the CBR concept was established. Recommendations and Perspectives  There is a growing demand for methods to assess the effects of contaminated sediments to benthic fauna and whole aquatic ecosystems. Such information is needed for sediment quality guidelines that are currently being developed in many countries and remediation processes. The use of body residues as a dose metric in metal toxicity studies may help to overcome difficulties related to bioavailability issues commonly faced in sediment toxicity studies. ESS-Submission Editor: Prof. Dr. Henner Hollert (henner.hollert@bio5.rwth-aachen.de)     

The first report of autochthonous non-vector-borne transmission of canine leishmaniosis in the Nordic countries

Background

Leishmania spp. are zoonotic protozoans that infect humans and other mammals such as dogs. The most significant causative species in dogs is L. infantum. In dogs, leishmaniosis is a potentially progressive, chronic disease with varying clinical outcomes. Autochthonous cases of canine leishmaniosis have not previously been reported in the Nordic countries.

Results

In this report we describe the first diagnosed autochthonous cases of canine leishmaniosis in Finland, in which transmission via a suitable arthropod vector was absent. Two Finnish boxers that had never been in endemic areas of Leishmania spp., had never received blood transfusions, nor were infested by ectoparasites were diagnosed with leishmaniosis. Another dog was found with elevated Leishmania antibodies. A fourth boxer dog that had been in Spain was considered to be the source of these infections. Transmission occurred through biting wounds and semen, however, transplacental infection in one of the dogs could not be ruled out.Two of the infected dogs developed a serious disease and were euthanized and sent for necropsy. The first one suffered from membranoproliferative glomerulonephritis and the second one had a chronic systemic disease. Leishmania sp. was detected from tissues by PCR and/or IHC in both dogs. The third infected dog was serologically positive for Leishmania sp. but remained free of clinical signs.

Conclusions

This case report shows that imported Leishmania-infected dogs may pose a risk for domestic dogs, even without suitable local arthropod vectors.