Sorption of phosphate by aluminium and iron(iii)-hydroxy species on mica surfaces

Freshly cleaved mica sheets with aluminium- or iron(III)-hydroxy species on the cationexchange surface were prepared by suitable treatment with AlCl₃ or FeCl₃. These surfaces were considered as model soilk mineral surfaces and their interaction with phosphate studied using techniques previously developed for the study of single planar surfaces.Adsorption isotherms for both the iron(III) and aluminium systems were very similar and could be interpreted as two Freundlich isotherms indicating two different adsorption processes, one operating below a solution concentration of 10^?5 M and thee other above. Results obtained from the continuous monitoring of adsorption indicate that a rearrangement of adsorbed phosphate occurs with time on both the aluminium- and iron(III)hydroxy surfaces. This rearrangement reduces the rate of desorption and could be a cause of phosphate fixation in soils.     

Yields of cultured Pacific oysters Crassostrea gigas Thunberg improved after one generation of selection

Parental families (G₀) in three lines of Pacific oysters were selected based on live weight and meat yields at harvest. The average live weight yield of progeny (G₁) from crossing G₀-selected lines in seven trials was 9.5% greater than that of nonselected control families and live weight yields were significantly greater (ANOVA, P<0.001) in four out of seven trials. The response to selection was greater if G₁ families were tested at the same site as their parents' selection site rather than at a different site, although this effect was only significant for G₁ families of cohort 5 (P<0.01) but not cohort 7 (P>0.05). A significant genotype×environment interaction affected yields in both cohort 5 and cohort 7 (ANOVA; P<0.001). In addition, correlation between the yields of the same families planted at both intertidal and subtidal sites was positive but weak (cohort 5, r=0.30; cohort 7, r=0.35), indicating that selection for high yield in one environment would likely result in a low correlated response in a different environment. Nonetheless, it was possible to identify six families in cohort 5 and four families in cohort 7 that were among the top 10 families at both sites. Further evaluation of families across a wider range of environments is needed to determine if it is possible to substantially improve yields by selecting “generalist” families that perform well along the whole Pacific coast, or whether it will be necessary to select lines that are suited to particular sites.     

Use of multifrequency bioelectrical impedance analysis for estimation of total body water and extracellular and intracellular fluid volumes in horses

OBJECTIVE: To evaluate the use of multifrequency bioelectrical impedance analysis (MF-BIA) for estimating total body water (TBW), extracellular fluid volume (ECFV), and intracellular fluid volume (ICFV) in horses. ANIMALS: 9 healthy mares. PROCEDURE: TBW and ECFV were measured by use of deuterium oxide and sodium bromide dilution techniques, respectively. Intracellular fluid volume was calculated as the difference between TBW and ECFV. Concurrently, MF-BIA recordings were obtained by use of 4 anatomic electrode positions and 3 measurements of length. Models for MF-BIA data were created for all combinations of length and anatomic electrode position. Models were evaluated to determine the position-length configuration that provided the most consistent estimates of TBW, ECFV, and ICFV, compared with values determined by use of the dilution techniques. RESULTS: Positioning electrodes over the ipsilateral carpus and tarsus and use of height at the tuber sacrale for length provided the closest estimate between values for TBW, ECFV, and ICFV predicted by use of MF-BIA and measured values obtained by dilutional techniques. This model had the narrowest 95% limits of agreement. CONCLUSIONS AND CLINICAL RELEVANCE: MF-BIA techniques have been used to predict changes in TBW, ECFV, and ICFV in healthy and diseased humans. Results reported in this study provide an equine-specific model to serve as the basis for further evaluation of MF-BIA in horses with altered fluid states. The MF-BIA techniques have a number of potential applications for use in horses, including evaluation of exercise physiology, pharmacologic studies, and critical-care management.     

Pharmacokinetics and clinical effects of a subanesthetic continuous rate infusion of ketamine in awake horses

OBJECTIVE: To determine the pharmacokinetics and clinical effects of a subanesthetic, continuous rate infusion of ketamine administered to healthy awake horses. ANIMALS: 8 adult horses. PROCEDURES: Ketamine hydrochloride was administered to 2 horses, in a pilot study, at rates ranging from 0.4 to 1.6 mg/kg/h for 6 hours to determine an appropriate dose that did not cause adverse effects. Ketamine was then administered to 6 horses for a total of 12 hours (3 horses at 0.4 mg/kg/h for 6 hours followed by 0.8 mg/kg/h for 6 hours and 3 horses at 0.8 mg/kg/h for 6 hours followed by 0.4 mg/kg/h for 6 hours). Concentration of ketamine in plasma, heart rate, respiratory rate, blood pressure, physical activity, and analgesia were measured prior to, during, and following infusion. Analgesic testing was performed with a modified hoof tester applied at a measured force to the withers and radius. RESULTS: No signs of excitement and no significant changes in the measured physiologic variables during infusion rates of 0.4 and 0.8 mg of ketamine/kg/h were found. At 6 hours following infusions, heart rate and mean arterial pressure were decreased, compared with preinfusion measurements. An analgesic effect could not be demonstrated during or after infusion. Pharmacokinetic variables for 0.4 and 0.8 mg/kg/h infusions were not significantly different. CONCLUSIONS AND CLINICAL RELEVANCE: Ketamine can be administered to awake horses at 0.4 or 0.8 mg/kg/h without adverse behavioral effects. The observed pharmacokinetic values are different than those reported for single-dose IV bolus administration of this drug.     

The influence of planting density on the production of ‘Goldfinger’ (Musa spp., AAAB) in the subtropics

‘Goldfinger’, a tetraploid banana produced from the Fundación Hondureña de Investigación Agrícola (FHIA) breeding program, was released to the Australian industry in 1995. It was promoted as an apple-flavoured dessert banana with resistance to Fusarium wilt race 1 and subtropical race 4, as well as resistance to black and yellow Sigatoka (Mycosphaerella fijiensis and M. musicola, respectively). This study was initiated to provide agronomic information to the banana industry, which was under threat from Fusarium wilt, on a new cultivar which could replace ‘Williams’ (AAA, Cavendish subgroup) or ‘Lady Finger’ (AAB, Pome subgroup) in those areas affected by Fusarium wilt. Also few studies had reported on the production characteristics of the new tetraploid hybrids, especially from subtropical areas, and therefore two field sites, one a steep-land farm and the other a level, more productive site, were selected for planting density and spatial arrangement treatments. The optimum density in terms of commercial production, taking into account bunch weight, finger size, length of the production cycle, plant height and ease of management, was 1680 plants/ha on the steep-land site where plants were planted in single rows with 2.5 m × 2.5 m spacings. However on the level site a double-row triangular layout with inter-row distances of 4.5 m to allow vehicular access (1724 plants/ha) gave the best results. With this arrangement plants were in an alternate, triangular arrangement along a row and a spacing of 1.5 m between plants at the points of each triangle and between each block of triangles.     

Characterization of two microparticle types for delivery of food to altricial fish larvae

The characteristics of two microparticulate types were determined for delivery of nutrients to fish larvae. A yeast-based commercial diet for larval fish (Microfeast Plus L-10, Salt Creek, Inc., Salt Lake City, UT, USA) was encapsulated within cross-linked protein-walled capsules (CLPWC) or gelatin-alginate beads (GAB). Microparticle stability was determined by encapsulating a nontoxic red dye (Poly R 478) within CLPWC or GAB. The stabilities of both particle types suggested that high molecular weight, water-soluble nutrients could be delivered to freshwater fish larvae without major losses from leaching. Acceptability experiments included determination of gut fullness and feeding incidence of zebrafish Brachydanio rerio larvae fed on the two particle types. Acceptability of GAB by first-feeding zebrafish larvae was significantly greater than that for CLPWC. Acceptability of CLPWC increased in larger larvae and was similar to that for GAB. Both particle types were broken down by first-feeding zebrafish larvae. Growth experiments with CLPWC showed that up to 40% substitution of Artemia nauplii could be accomplished without reduced growth and survival of zebrafish larvae after a feeding period of 8 days. Twenty per cent substitution of Artemia nauplii could be achieved with GAB without reduced growth and survival.