Analysis and Assessment on Heavy Metal Contamination in Cotton Seeds of Hunan Province

[Objective] In order to guarantee the quality and safety of cotton products and to explore the feasibility of alternative planting, the contamination condition of the heavy metals in cotton seeds in Hunan province was investigated and evaluated. [Method] Fifty-six cotton seed samples, collected in 6 counties of Hunan province, were collected to determine 6 indicators including cadmium, lead, copper, chromium, mercury and inorganic arsenic contents. This was followed by pollution index calculation, correlation analysis, and cluster analysis. [Results] The range of comprehensive pollution indexes of Junshan district, Anxiang county, Nanxian county, Wangcheng and Dingcheng districts varied between 0.366 5–0.577 0, which belonged to a secure level. However, the single pollution indexes of Hengyang county are relatively high. The comprehensive pollution index of Hengyang county was 0.801 6, meaning a mild pollution level. [Conclusion] The pollution status of cadmium, lead, copper, chromium, mercury and arsenic in Hunan cottonseed samples are generally acceptable. Cotton could be a substitute for rice on contaminated soil.     

水流作用下临水岸坡稳定性计算模型

河流崩岸是我国堤防安全面临的重大问题,汛期前后崩岸诱发大量的滑体进入河道,影响航运,给沿岸人民正常生产生活带来重大影响。针对水流作用下临水岸坡失稳问题,综合考虑坡表静水压力、内部孔隙水压力、边坡几何形状等因素的影响,构建了楔形岸坡稳定计算模型,并结合长江干流芙蓉大堤段崩岸实例,分析了各因素对岸坡稳定的作用。结果表明,坡表与地下水位升降及二者之差,对岸坡稳定影响较大,且水流的淘刷深度也直接影响着岸坡整体稳定。     

考虑水文变异的水库生态流量研究

为探讨水文变异对生态流量影响,确定最佳水库生态流量推求方法,针对尼尔基水库生态问题,采用Mann-kendall突变检测法、滑动T检验法和有序聚类法,结合序号总和理论和Spearman相关系数计算对水文时间序列作综合识别,确定水库发生水文变异年份为1963年和1999年。利用NGPRP法和逐月频率年内展布计算法分别计算天然状态、次天然状态、现状和不考虑水文变异条件下最小生态流量和适宜生态流量。参考Tennant法评价结果表明水库生态系统退化主要受人类扰动影响,观察次天然状态和不考虑变异状态下生态径流过程,最小生态流量占多年平均流量百分数相差9.21%和1.70%,适宜生态流量相差3.04%和1.47%。研究应更多考虑次天然生态径流过程,其最小生态流量仅可作为生态流量下限。     

Fluctuating salinity effect on Sphoeroides annulatus (Jenyns 1842) physiological responses

Euryhaline fish, such as the Bullseye puffer Sphoeroides annulatus (Jenyns 1842), experience sudden salinity changes in their natural environment, which is more common than the exception, so they must adapt to survive and cope with extreme salt conditions. Therefore, Bullseye puffer juveniles were exposed to short‐term stress (39 hr) by fluctuating salinity conditions (41, 35, 29, 23, 17, 11, 5, 11, 17, 23, 29, 35, 41 psu) with a 3‐hr interval between each point at 26 ± 1ºC in a respirometer chamber and acclimation reservoirs. Responses to oxygen consumption rate (OCR: 23–35 mg O₂ h^–1 kg^–1), ammonium excretion rate (AER: 1–1.85 mg NH4⁺ h^?1 kg^?1), oxygen‐nitrogen atomic ratio (O:N 17–30), osmoregulatory pattern (blood osmotic pressure from 342.4 to 332.8 mmol/kg) and changes in expression levels of Na⁺/K⁺‐ATPase in the gills (higher values at higher salinities) were measured. Although some signs of stress were detected below the iso‐osmotic point (11.4 psu), the puffer fish is a strong euryhaline fish that survives under these conditions. Nonetheless, it could recover when salinity returned to the initial acclimation point because Sphoeroides annulatus is able to live in a wide range of environments with wide natural salinity fluctuations; thus, a common practice in aquaculture has been to expose fish to low salinity for several reasons discussed in this study. This capacity reveals its high plasticity to saline adaptation from 41 to 5 psu an up from 5 to 41 psu, all in less than 2 days.     

农用运输车用液力缓速器的设计与仿真分析

为解决农用运输车长时间制动造成的热衰退问题,参考THB40液力缓速器,基于相似理论设计了一款液力缓速器。计算确定了其设计制动力矩值和定转子叶轮参数,运用Pro/E构建了其三维结构,并在CFX14.5平台上以SST-kω湍流模型进行仿真计算。结果表明:制动力矩符合设计要求,流场的特征与THB40流场特征高度一致,为设计适合农用车用液力缓速器提供了借鉴。     

基于DTW距离的拖拉机传动轴载荷样本长度计算方法

针对工程领域载荷样本长度确定方法对农业机械载荷适用性较差的问题,提出了一种基于动态时间扭曲(DTW,Dynamic Time Warping)距离计算载荷样本长度的方法。首先,运用无线扭矩传感器获取犁耕作业下拖拉机传动轴的动态载荷,结合传动轴犁耕作业下的载荷特点,划分作业工况;再将作业循环叠加并经过归一化处理后进行DTW距离计算,确定传动轴载荷样本长度;最后,计算参数外推中均值混合正态分布函数的拟合参数相对误差。结果表明,运用DTW距离方法确定的载荷样本长度,能够使均值双正态分布函数拟合得到的参数相对误差保证在10%以内。近似均值精度估计法和均值曲线拟合法的拟合参数相对误差最大值分别为126.06%和80.62%,而基于DTW距离计算方法的拟合参数相对误差最大值为5.43%,验证了基于DTW距离的载荷样本长度计算方法的适用性。研究结果可为拖拉机传动轴田间试验载荷样本长度确定提供参考。     

燃烧室与油束匹配的动态计算

介绍了一种燃烧室与油束匹配的动态计算方法和计算过程,通过计算可以保证在整个供油持续期内燃油喷射在燃烧室内特定的区域,避免喷射到活塞顶部和燃烧室底部,确保油、气的充分均匀混合,避免因燃油喷射到活塞顶部和燃烧室底部而引起的燃烧不充分,从而造成油耗的升高和颗粒排放的增加。针对一种欧Ⅳ排放的四缸柴油机进行了计算验证。     

用EL-5100计算器现地控制抚育强度

笔者采用EL-5100计算器进行抚育强度的计算,并对设计抚育强度和计算抚育强度进行了比较。通过建立回归方程,进行方差分析和几何解析,证实该计算方法的实用性和可行性。结果表明,该方法能够使外业调查在1 min~2 min的时间内现地控制抚育强度,为天然林保护工程快速确定抚育强度提供参考。     

内循环(IC)厌氧反应器设计计算方法的探讨

文章论述了内循环(IC)厌氧反应器的设计计算方法,在对IC反应器水力特性分析的基础上,对有人提出计算升流管内液体升流速度的关系式进行了修正,并提供了有用的设计计算参数,最后,详细地提供了设计计算实例.     

干旱区平原水库防蒸发浮板的力学

针对干旱区平原水库无效蒸发损失严重这一特点，提出用轻质板覆盖部分库区水面以减少无效蒸发，提高水库的有效利用率。为实现这一目标，在合理假设的基础上，本文应用波浪理论、材料力学、弹塑性力学等基础理论建立轻质浮板的计算模型，从而确定单块浮板的物理和几何参数，为水库防蒸发节水工程实施提供计算依据。