大豆小肽螯合铁的制备工艺及光谱分析研究

通过铁源筛选比较得知,氯化亚铁比较适合与大豆小肽进行螯合反应制备大豆小肽螯合铁,利用响应面法优化了大豆小肽螯合铁的制备工艺,优化结果为:小肽与亚铁盐质量比4∶1,反应pH5.0,反应温度40℃,得到离子螯合率平均值为56.81%,经中试车间生产试制得到大豆小肽螯合铁的得率是78.3%,螯合率为82.39%,检测大豆小肽螯合铁的主要成分中的蛋白含量为78.94%,铁的含量为10.87%。红外和紫外光谱分析检测结果显示:大豆小肽和大豆小肽螯合铁(Fe~(2+))红外吸收峰的强度在不同波长位置上有明显的变化,大豆小肽螯合铁(Fe~(2+))在紫外波长上发生了明显的位移且宽化,表明大豆小肽螯合铁(Fe~(2+))形成了络合物。同时对大豆小肽螯合铁的结构进行了预测。     

鲢鱼骨胶原多肽螯合钙的制备研究

文章探讨了以鲢（Hypophthalmichthysmolitrix）鱼骨为原料，采用风味蛋白酶酶解制备骨胶原多肽水解液，剩余骨渣经乳酸提取制备骨粉酸解液（钙液），研究其通过螯合制备鲢鱼骨胶原多肽螯合钙的工艺条件。分析了酶解时间对鲢鱼骨蛋白酶解产物产品品质和功能特性（溶解性和热稳定性）的影响以及采用乳酸提取鲢鱼骨中钙时提取温度对钙溶出率的影响，并以螯合率为指标，考察pH、时间、温度和多肽液与钙液体积比对螯合反应的影响。结果表明，在温度50℃，按原料鱼排质量0．09％加入风味蛋白酶酶解30min制备出的鲢鱼骨胶原多肽具有良好的产品品质和功能特性；乳酸提钙时提取温度对钙溶出率没有显著性影响（P〉0．05）；在pH8、温度25℃条件下，多肽液与钙液体积比1：1反应40min得到的鲢鱼骨胶原蛋白螯合钙螯合率最高（85．24％）。     

纳米二氧化钛光催化降解毒死蜱的动力学研究

以高压汞灯为光源,研究纳米二氧化钛(TiO2)降解毒死蜱的反应动力学,考察纳米TiO2用量、毒死蜱起始质量浓度及溶液pH值对毒死蜱光催化降解速率的影响.结果表明,纳米TiO2最佳用量为50～100 mg/L,毒死蜱初始质量浓度在5～80 mg/L时,其降解反应符合一级反应动力学规律,表现为毒死蜱质量浓度越大,降解速率常...     

螯合剂对铀镉污染土壤中蚕豆幼苗生理特性影响

通过盆栽试验研究了在不同浓度EDTA、柠檬酸、草酸3种螯合剂作用下不同浓度铀镉复合污染(分别用W1、W2表示)对土壤中蚕豆(Vicia faba L.)幼苗体内叶绿素、丙二醛和细胞质膜透性的影响.结果表明,在所设的两个土壤污染浓度下,较高土壤污染浓度(W2)中植物受损伤程度高于较低土壤污染浓度(W1)中的植物受损伤程度,由此得出较高土壤污染浓度可能更有利于蚕豆对铀镉的吸收;蚕豆的整个生长过程中,对于叶绿素而言,在污染土壤中添加5 mg·kg-1的草酸,对其含量影响最大,可能有利于促进蚕豆对土壤中铀和镉的吸收,添加2.5 mg·kg-1的柠檬酸次之;对于丙二醛,向污染土壤中添加10 mg·kg-1的草酸,对其含量影响最大,可能有利于蚕豆对土壤中铀和镉的吸收,添加2.5 mg·kg-1的柠檬酸次之;在细胞质膜透性上,向土壤中添加5 mg·kg-1草酸,对其含量影响最大,可能更有利于促进蚕豆吸收土壤中的铀和镉,而添加5 mg·kg-1的柠檬酸次之.而EDTA在整个试验中都表现出了对植物较大的生物毒性.     

重金属污染土壤几种生物修复方式比较

土壤重金属污染是全球普遍存在的问题,生物修复因其环境友好且成本效益高而得到广泛关注。但不同生物修复技术有其优势和局限性,充分了解每种修复技术的特点,才能更经济、有效地对污染土壤进行修复。本研究阐述对比了目前的土壤重金属生物修复方法,包括植物修复（植物挥发、植物固定和植物提取）、转基因植物提取、螯合辅助植物修复、微生物辅助植物修复等技术的机制、优势、局限性和适用性等方面的差异。综述提出有效的生物修复技术需要土壤化学、植物生物学、遗传学、微生物学和环境工程等多学科的有机结合。根据污染土壤的特点,结合具有相应改良特性的转基因植物,是实现污染土壤大面积修复的有效方法。同时,农艺措施对天然超级积累植物的生物量和重金属提取能力的刺激作用还需要进一步挖掘。植物修复可以与其他几种传统修复技术有效结合,利用转基因技术建立土壤+植物+微生物的组合是未来修复技术发展的最佳途径。     

离子溅射银对光电协同灭青霉菌的影响

为解决果蔬采后易受微生物作用而腐败变质的问题,该文进行了纳米二氧化钛(TiO_2)光催化技术灭活园艺产品冷藏环境中青霉菌的研究:以活性炭纤维(activated carbon fiber,ACF)为载体,以粉末浸渍-提拉法制备TiO_2-ACF薄膜,采用离子溅射法在ACF薄膜上作贵重金属银沉积处理,研究表面溅射与底层溅射纳米Ag粒子及施以外加电压处理对TiO_2-ACF薄膜光催化灭活青霉菌的影响及机理。结果显示,不同的溅射方式对试验结果有不同的影响,其中底层溅射效果较好,120 s时光催化灭活青霉菌速率最高;外加电压可提高TiO_2-ACF薄膜光催化速率,75 V是最优值,且光电催化作用效果优于单独光催化和电催化的总和。对负载的ACF薄膜表征分析,发现离子溅射较均匀地实现了纳米Ag-TiO_2混合粒子在ACF薄膜的表面及内部负载。研究结果为纳米TiO_2光催化技术在灭活园艺产品冷藏环境中青霉菌的实际应用提供参考。     

Evaluation of selected metal nanoparticles on hatching and survival of larvae and fry of Indian major carp,rohu (Labeo rohita)

Different laboratory synthesized metal nanoparticles viz. Copper oxide (CuO), Zinc oxide (ZnO) and silver doped titanium dioxide (Ag‐TiO₂) were studied for their effect on hatching and survival of larvae and fry of Indian major carp, rohu, Labeo rohita both in direct application in tank water & coated onto tanks. Among these nanoparticles, CuO and ZnO nanoparticles exhibited highest percentage of hatching in both direct addition (78.0 ± 3.1% and 78.05 ± 4.2%, respectively) and coating onto tanks (58.6 ± 2.1% and 61.2 ± 2.7%, respectively) at 1 mg mL^?1 while least percentage of hatching was recorded in Ag‐TiO₂ nanoparticles irrespective of its concentration & mode of supplementation. Highest survival of L. rohita fry (50.13 ± 2.2%) was observed after 15 days post hatching in CuO coated tanks followed by ZnO coated tanks (38.6 ± 2.8%) while least was recorded in Ag‐TiO₂ coated tanks (22.53 ± 3.0%). However in control tanks coated with Poly‐Urethane base with hardener and uncoated control tanks, the survival was 42.4 ± 1.2% and 41.36 ± 1.8% respectively. Further, significantly lower microbial load of water was recorded in CuO nanoparticles coated tanks (1.5 × 10¹⁰ CFU L^?1) as compared to uncoated control tanks (1.1 × 10¹⁶ CFU L^?1) without affecting water quality parameters. On the other hand, in Ag‐TiO₂ coated tanks, significantly lower microbial load (1.0 × 10⁶ CFU L^?1) as compared to uncoated control tanks at 15 days post hatching was recorded. However, Ag‐TiO₂ was toxic to L. rohita larvae & fry both in direct application and coating onto tanks. Considering the beneficial effects of CuO nanoparticle application, it has the scope of being used in a more eco‐friendly way in hatchery operations.     

A simulated experiment on the high titanium slag rheological behavior

The rheological property of high titanium slag is a main factor to influence the vanadium titanomagnetite smelting in blast furnace. It plays a great role in discharging slag, separating iron and slag and even the life of blast furnace hearth. The acrylonitrile-butadiene-styrene multipolymer(ABS) dense suspension is taken to simulate the system of high titanium slag. Apparent viscosity is measured by a NXS-11A rotating cylinder viscometer. The impact of temperature, volume fraction and particle sizes on the suspension apparent viscosity is studied. The results show that temperature and volume fraction have a strong influence on the suspension apparent viscosity, while the particle size has a weak effect. The suspension shows Bingham behavior within a wide concentration range. The dependence of the appear viscosity on temperature and amount of solid addition can be described by a binary function equation.     

氨基多糖螯合盐对扣蟹非特异性免疫力的影响

[目的]探讨氨基多糖螯合盐对扣蟹非特异性免疫力的影响。[方法]通过在配合饵料中添加氨基多糖螯合盐,研究其对扣蟹非特异性免疫力[碱性磷酸酶(AKP)活性、酸性磷酸酶(ACP)活性、超氧化物歧化酶(SOD)活性、溶菌酶活性]的影响。[结果]氨基多糖螯合盐可以有效提高扣蟹AKP、ACP、SOD和溶菌酶活性。[结论]在饲料中添加氨基多糖螯合盐对于增强扣蟹非特异性免疫力有一定功效。     

船用钛合金基座铸造工艺研究

针对薄壁、结构复杂的船用钛合金基座,采用机加工石墨型的造型方法,设计了合理的铸造工艺,成功生产重71kg、外形尺寸为980×736×275、壁厚为6mm的钛合金基座铸件,文章中所论述的工艺路线经受了实践考验,对此类复杂零件的铸造生产具有重要意义。