Changes through time in traits of poplar clones in selection trials

Growth, survival, stem characteristics, resistance to wind, and canker disease of 51 poplar clones were evaluated at age 9 and 10 years, and compared to measurements at age 3 in two trials on the Lower Valley of the Colorado River, Argentina. About 30% of the clones in both trials had large changes in growth rankings at age 9 and 10 compared to rankings at age 3. Canker incidence increased about 4-fold between age 3, and measurements at age 9 and 10. Stem form was in general satisfactory, and wind incidence was almost nil. In trial 1, clones 588–1, Conti 12, 582–41, and 582–5 occupied the upper positions in the growth rankings at age 3 and 10, and the clone 588–1 ranked first both in growth and canker incidence in 1998. Stem growth trajectories of clones with similar growth rates did not differ among clones with, and without canker disease. In trial 2, the range in growth among clones was narrower than in trial 1, and canker disease, although of minor incidence, was present in most clones at age 9. Some of the P. deltoides clones in the trials had similar growth, and less canker disease than the Euroamerican clones commonly grown in the region, but progressive canker incidence should be addressed with additional selection trials.     

谷子秸秆剪切力与其饲料营养特性变化规律及相互关系

为探究谷子秸秆力学性质与其饲料特性的变化规律及相互关系，选用谷物完熟期的谷子秸秆，将其分为5段（近根部、中下部、中部、中上部、上部）并每隔7 d进行秸秆节间、茎节力学性质（剪切、压缩）和饲料特性（形态指标、营养成分）测定。试验结果表明：谷物完熟后，随着时间的推进，秸秆节间、茎节剪切力、抗压强度、干物质含量、纤维素含量、半纤维素含量和木质素含量总体上呈增大趋势，而秸秆含水率、当量直径、横截面积、线性密度和粗蛋白含量总体上呈减小趋势。谷子秸秆单位直径剪切力与含水率和线性密度呈负相关关系（R2≥0.903），与其干物质、纤维素、半纤维素和木质素含量呈正相关关系（R2≥0.845），与其粗蛋白含量无显著相关关系（P>0.05）。采收期内，谷子秸秆基部起秸秆剪切力至顶部逐渐增大，且剪切力与当量直径、横截面积呈正相关关系（R2≥0.916）。试验表明谷子秸秆饲料特性指标验证试验值与预测值相对误差不大于6.48%，预测模型合理。测量秸秆剪切力可用于预测其形态指标参数和营养成分含量，进而一定程度地反映秸秆饲用价值和反刍动物择食趋向。采收期内，谷子中部及以上秸秆单位直径剪切力显著小于其近根部（P<0.05），更适合饲用；且谷物完熟后，及时采收可避免秸秆饲用价值降低。该研究可为高效利用谷子秸秆资源提供参考。     

Expected selection efficiency for resistance to cacao pod rot (Phytophthora palmivora) comparing leaf disc inoculations with field observations

Summary A genetic analysis of resistance of cacao to Phytophthora palmivora was carried out in a 5 × 5 diallel and in a 4 × 2 NC II factorial design, involving cross-progenies and parental clones planted in the nursery and field, respectively. Resistance was scored in the laboratory by inoculation of leaf discs with P. palmivora spores with four replicates and, for the factorial design, results were compared with the percentage of rotten pods in the field assessed over a seven-year period. Significant differences between genotypes were observed for both laboratory and field evaluation methods. For the laboratory test, no reciprocal effect was observed and plant effects within seedling progenies were more significant than plant effects within clones. General combining ability was the main source of variation but specific combining ability was also significant for the leaf disc test applied to the diallel. Heritabilities increased with the number of replicates, reaching values of 0.34 and 0.67 for narrow sense heritability, and 0.60 and 0.67 for broad sense heritability, for the diallel and the factorial design, respectively. These values were higher than observed for the percentage of rotten pods in the field in the factorial design (0.42 and 0.47, respectively). For the leaf test, the expected genetic gains were around 30% with a selection intensity of 5%. The existence of significant genetic (0.71) and phenotypic (0.39) coefficients of correlation between resistance on leaves and percentage of rotten pods in the field in the factorial design confirms the feasibility of using the leaf disc test for early selection of resistance to Phytophthora pod rot of cacao.     

Diallel study of open-pollinated maize varieties in Trinidad

Summary In Trinidad, maize (Zea mays L.) is primarily harvested in the immature stage as green ears for human consumption. The purchase of popular imported hybrid seed has become a substantial component of the economic inputs of maize production. The objectives of this study were to investigate combining abilities and heterotic patterns among available open-pollinated varieties and to assess correlations among five important traits: time to silking, plant height, grain yield, ear size, and marketable ears per hectare. General combining ability was significant for all traits. Specific combining ability was significant for all traits except ear size. Three intervarietal crosses showed moderate levels of heterosis (10–27%), and several yielded similarly to the control hybrids, Pioneer X304 and Pioneer 3078. The cross Acid Soil Tolerant 1991 SA-3 X ICTA Farm Corn was selected as the most suitable base population for mass selection. Phenotypic and genotypic correlations among the five traits studied were all positive and significant. Populations which flowered early were shorter and yielded less than the late flowering and taller populations and population crosses included in this study.     

Relationship of morphological variables to rubber production in guayule

Summary The objective of this study was to find measurable characters to aid the plant breeder in predicting both rubber percentage and rubber yield of guayule (Parthenium argentatum Gray). A field of 234 guayule breeding lines was harvested by clipping in February 1986. Forty-two of these lines were selected for further evaluation on the basis of superior regrowth, rubber content and yield. These 42 lines were reharvested in February 1987. Nineteen variables were evaluated including percent rubber and resin, rubber and resin yield (g/plant), plant height (cm), width (cm), and volume (m³), fresh and dry weight (kg/plant), percent dry weight, stem number, mean stem diameter (cm), total and mean stem circumference (cm), total and mean stem area (cm²), total stem circumference/total stem area (cm^-1), and regeneration at two dates. Dry weight (kg/plant) had the best correlation to rubber yield (r=0.85), and plant volume best predicted dry weight (r=0.83). These variables did not correlate as highly with percent rubber. The best statistical regression model for percent rubber included four variables, fresh and dry weight, percent dry weight, and plant volume. This model accounted for 51% of the variation. In comparison, the best regression of rubber yield had an R²=0.85 for plant height and width, volume, and dry weight.     

Protein yield of oats as determined by protein percentage and grain yield

Summary Relationships among the traits protein percentage, grain yield, and protein yield of oats were studied with F₂-derived lines in F₃ and F₄ from 27 matings obtained by crossing high-protein with high-yield oat lines. High-protein parents were (a) selections from an Avena sativa bulk, (b) selections from three-way matings in which an initial parent was A. sterilss, and (c) cultivars. High-yield parents were derived from backcross populations involving A. sterilis accessions as donor parents.Significnnt genetic variation existed among F₂-derived lines for grain and protein yield in all matings and for protein percentage in all but one mating.Protein percentage had a highly significant negative correlation with grain yield (r=–0.33^**) when pooled over all matings, but in five, these two traits were not correlated. Overall, protein percentage showed a small negative correlation with protein yield (r=–0.09^*), and protein and grain yields had a high positive association (r=0.98^**). F₂-derived lines with both high protein percentage and high grain yield were obtained.High transgressive segregates for protein percentage occurred in two matings, for grain yield in nine, and for protein yield in 14. Most high transgressive segregates for protein yield were high because of high grain yield only, but in four matings, lines were found where protein yield was increased by concurrent increases in both protein percentage and grain yield.Only a few specific parental combinations between high-protein and high-yield parents produced segregates in which increased protein percentage contributed materially to high-protein yields.Journal Paper No. J-11264 of the Iowa Agriculture and Home Economics Experiment Stn., Ames, Iowa 50011. Project 2447.     

Genetic relationships between attributes in sugarcane clones closely related to Saccharum spontaneum

Summary Saccharum spontaneum is being used in sugarcane breeding programs in attempt to improve characteristics such as ratooning ability and stress tolerance. A population of F₁ (Saccharum officinarum or commercial variety x S. spontaneum) and F₁ x F₁ sugarcane clones was evaluated for sugar yield and a range of yield components in a plant and two ratoon crops. The aim was to determine genetic correlations between attributes in clones with a large component of S. spontaneum, that could be used to help derive appropriate selection indices in such populations.There were close associations between the same attributes measured in different crop-years and the associations between different attributes were generally similar across crop-years. Stalk number and fibre content were positively correlated, as were stalk weight and CCS. The latter two attributes (which are low in S. spontaneum but high in S. officinarum) were negatively correlated with the former two (high in S. spontaneum, low in S. officinarum). Sugar yield was more closely associated with stalk weight and CCS than with stalk number but became more closely associated with stalk number with successive ratoon crops.CCS was positively correlated (r_g=0.55) with cane yield in the plant crop but showed a small negative correlation with cane yield (r_g=–0.20) in the second ratoon crop. CCS (measured in any crop) also had a negative correlation with cane yield in the ratoon crops expressed as a percentage of plant cane yield. This suggests that CCS is negatively correlated with levels of traits contributing to ratooning ability. Intensive selection among such populations for CCS without consideration of ratooning performance may reduce the frequency of favourable specific ratooning characteristics.Abbreviations CCS commercial cane sugar     

Selection for resistance to Septoria nodorum in wheat

Summary A population of 572 F₂ derived F₃ lines from six crosses were used to estimate parameters relevant to selection for resistance to Septoria nodorum of wheat. Lines were grown in disease free (fungicide sprayed) and inoculated microplots in 2 replications of a split-plot design in a single environment in 1977. Average yield reduction due to disease was approximately 50%; this was associated with an average septoria score of 50% on the flag leaf, an average septoria score of 42% on the head, and a reduction of 37% in seed weight. Low S. nodorum scores were correlated with late heading date, tall plant height, high grain yield, and high seed weight in diseased plots, and high seed weight % (seed weight in diseased plots expressed as a percentage of seed weight in fungicide sprayed plots).Restricted selection indexes were used to study the relative contributions of disease escape, true resistance, and tolerance to variability in grain yield in diseased plots, seed weight in diseased plots, and seed weight %. True resistance appeared to be the most important factor causing variation in grain yield in diseased plots and seed weight %. Tolerance and escape seemed to be more important for seed weight in diseased plots.Heritabilities of S. nodorum scores on the flag leaf and head were 63% and 52%, respectively. Leaf and head scores could be used most effectively as selection criteria to upgrade resistance in a population before harvest.Selection for high seed weight % slightly reduced yields in disease free plots, although yield in diseased plots and seed weight in diseased plots were increased. However, selection for increased yield or increased seed weight in diseased plots improved yield in disease free plots. It is suggested that direct selection for yield or seed weight in diseased plots is likely to achieve more desirable goals than selection for seed weight %.     

Evaluation of Early Generation Testing in Chickpea1)

Inter-generation correlations between F₂-F₃, F₂-F₄ and F₃-F₄ in six crosses of chickpea were calculated by using individual plant/progeny means. In general, correlation values in case of plant height, seeds per pod and 100-seed weight were higher between F₃ and F₄ than those between F₂ and F₃ and F₂ and F₄. However, inter-generation correlations were mostly non-significant in case of pods per plant and grain yield. These results clearly show that selection in F₃ can be fruitful for seeds per pod and 100-seed weight. However, selection for pods per plant and grain yield in early generations may not show any relationship with later generation performance for these traits.     

Seedling emergence,coleoptile length,and plant height relationships in crosses of dwarf and standard-height wheats

Summary Seedling emergence was closely correlated with coleoptile length and plant height among parents, F₂ and F₃, populations of crosses involving dwarf wheats Olesen Dwarf (CI 14497), Norin 10 derivative D6301, Tom Thumb derivative D6899, and the standard-height varieties Ramona 50 and Nainari 60. Genetic mechanisms that governed plant height also influenced coleoptile length, but the relative effects of genes showing dominant or epistatic effects appeared to be different. With respect to the two parents involved in each of 15 crosses, mean F₂ coleoptile lengths were consistently closer to the low parent value than were corresponding mean F₂ plant heights. A slight curvilinear relationship was also found between coleoptile length and plant height of F₃ lines. The results suggest that selection of semidwarf wheats with long coleoptiles and improved emergence properties from crosses involving the dwarf wheats of this study would be unlikely.