The effects of density and artificial substrate on intensive shrimp Litopenaeus vannamei nursery production

Recirculating aquaculture systems (RAS) can be installed indoors, allowing year-round production of tropical animals in nearly any climate. A nursery phase is commonly used in Litopenaeus vannamei production since it allows for enhanced biosecurity and better quantification of animals while reducing space requirements. However, it is unclear whether animal density and inclusion of artificial substrate may improve shrimp performance during the nursery phase. In this experiment, we compared shrimp production parameters in two stocking densities with or without the use of an artificial substrate by creating four treatments: low-density LD; 1500 PL/m⁻³, low-density with substrate LDS, high-density HD; 3000 PL/m⁻³), and high-density with substrate (HDS). The LDS and HDS treatments included 0.46-m² of high-density polyethylene 2.5-cm mesh as a substrate, which increased the tank surface area by 21 %. Each treatment was randomly assigned to four 160-l culture tanks, each with a biofilter. The shrimp had an initial weight of 4 mg and were grown for 50 days. The low-density treatments had significantly higher dissolved oxygen (DO) and pH than the high-density treatments (P ≤ 0.001). Specifically, LDS had the highest DO and pH followed by the LD, HD, and HDS treatments, respectively. High-density treatments had significantly higher NO₂-N levels than low-density treatments during week 2 of the experiment when an unusually high concentration of nitrite was observed. FCR was significantly lower in both low-density treatments than in high-density treatments. At harvest, the total biomass (kg m⁻³) was significantly higher in high-density treatments than in low-density treatments (P ≤ 0.001), and the HDS treatment had a significantly greater biomass output than HD. Producers should consider artificial substrate and higher densities during nursery production to maximize shrimp production; however, the effects on water quality should also be taken into account.     

番茄斑萎病毒病抗性种质筛选及人工接种鉴定方法优化

对154份番茄材料(包括普通番茄76份,樱桃番茄78份)进行两年两次田间番茄斑萎病毒病的病情指数调查,筛选出14份对番茄斑萎病毒病具有稳定抗性的番茄材料,利用sw-5-2共显性SCAR标记对田间表现抗病的材料进行分子标记鉴定,发现3份抗病材料携带抗番茄斑萎病毒病的Sw-5基因。为缩短番茄斑萎病毒病人工接种鉴定周期,以含有sw-5的抗病材料H8和感病材料M82为研究对象,设置4、6、8、10片真叶4个接种时期,分别在接种后14、21、28 d进行病情指数调查和抗性分级,结果表明,6片真叶期接种,接种后28 d进行病情调查即可有效鉴别植株番茄斑萎病毒病抗性,与8、10片真叶期接种效果相同,人工接种抗病性鉴定效率显著提升。     

Polymerisation of gluten proteins in developing wheat grain as affected by desiccation

The breadmaking quality of wheat is affected by the composition of gluten proteins and the polymerisation of subunits that are synthesised and accumulated in developing wheat grain. The biological mechanisms and time course of these events during grain development are documented, but not widely confirmed. Therefore, the aim of this study was to monitor the accumulation of gluten protein subunits and the size distribution of protein aggregates during grain development. The effect of desiccation on the polymerisation of gluten proteins and the functional properties of gluten were also studied. The results showed that the size of glutenin polymers remained consistently low until yellow ripeness (YR), while it increased during grain desiccation after YR. Hence, this polymerisation process was presumed to be initiated by desiccation. A similar polymerisation event was also observed when premature grains were dried artificially. The composition of gluten proteins, the ratios of glutenin to gliadin and high molecular weight-glutenin subunits to low molecular weight-glutenin subunits, in premature grain after artificial desiccation showed close association with the size of glutenin polymers in artificially dried grain. Functional properties of gluten in these samples were also associated with polymer size after artificial desiccation.     

父母本不同行距配置对昆虫授粉效率的影响

为探讨昆虫为杂交大豆授粉的行为,提高授粉效率,以大豆细胞质雄性不育系JLCMS34A和保持系JLCMS34B为材料,研究父母本3种行距配置(T1、T2、T3)对昆虫授粉行为及产量构成的影响。结果表明:行距配置T2条件下昆虫授粉效率最高,母本单株粒数最多,为45.98个(2011年),与T1、T3差异达到显著水平,T3配置授粉效率最差,单株粒数最少,为32.06个(2012年),与T1、T2差异达到极显著水平。在吉林省洮南地区适当缩小父母本行距,增加母本间行距可有效促进昆虫授粉效率,提高结实率。     

Prediction of baking results from farinograph measurements by using stepwise linear regression and artificial neuronal networks

In an effort to extract additional data from farinograph experiments a model was developed to simulate the measurements and correlate the parameters of the model with results from baking tests. This additional information can be used in bakeries to predict the baking properties of the flours and adjust the recipes to maintain a constant product quality. For this eight different flours were characterized with a farinograph and 13 different results from baking experiments. An approach with five nonlinear differential equations was able to model the farinograph measurements very well (average R² = 0.995 ± 0.005). While a stepwise multilinear regression only showed weak correlations in cross validation between a single parameter of the model and the baking volume (R² = 0.745) and the volume yield (R² = 0.796) respectively, the artificial neuronal network was more successful. For the baking weight (R² = 0.926), the dough yield gross (R² = 0.909) and net (R² = 0.913) strong correlations were found. A good correlation for the baking volume (R² = 0.853) was also determined, while the volume yield showed comparable results to the linear regression (R² = 0.792).     

运用植被指数时序特征对落叶松人工林分类

为探究植被指数时序特征是否有利于落叶松人工林提取,以孟家岗林场为研究试验区域,根据落叶松人工林季相和物候特征,利用Landsat8OLI影像数据提取研究区内5种植被的归一化植被指数(I NDV)、差值植被指数(I DV)、比值植被指数(I RV)、增强型植被指数(I EV),构建相应的植被指数时序特征。采用最大似然和随机森林两种方法对单一时相影像和加入植被指数时序特征的影像进行对比试验。结果表明:影像中加入植被指数时序特征后,最大似然算法的分类总体精度为89.53%,Kappa系数为0.87,比单一时序特征的影像分类精度提高了13.35%;随机森林算法的森林类型分类总体精度为93.22%,Kappa系数为0.92,比单一时序特征的影像分类精度提高了19.8%。因此,加入植被指数时序特征后能得到更高的落叶松人工林提取精度。