一氧化碳(CO)在植物体内的生理生化作用研究进展

为了促进一氧化碳(CO)在植物生理生化方面的研究,本文归纳了CO在植物体中的生物合成途径,CO作为信号分子对植物各种生理功能的调控,以及CO与其他信号分子之间的相互作用。经过分析得出,CO在植物生物胁迫过程中的作用及其作用机制方面的研究还很少,因此,CO在这方面的研究将会成为今后的研究重点。     

芹菜水孔蛋白基因AgPIP2;1的克隆及其对非生物胁迫的响应

为了研究芹菜质膜内在蛋白基因的序列特征及其在非生物胁迫条件下的表达特性,探讨其抗逆功能,以芹菜品种六合黄心芹为试验材料,通过RT-PCR技术克隆AgPIP2;1基因,通过生物信息学软件分析其核苷酸和氨基酸序列特征,并采用荧光定量PCR技术检测其在不同组织的表达及其对非生物胁迫的响应。结果表明,AgPIP2;1基因含有1个861 bp的开放阅读框,编码286个氨基酸,其编码的蛋白属于PIP2类蛋白。氨基酸序列分析显示,AgPIP2;1含有高度保守的NPA基序以及高等植物PIP蛋白的保守序列,与其他物种PIP2类蛋白具有较高的同源性,与胡萝卜DcPIP2;1的氨基酸序列同源性达到97.90%。在亲缘关系上与大豆GmPIP2;1、胡萝卜DcPIP2;1和绿豆VrPIP2;1较为接近。实时荧光定量PCR技术分析表明,AgPIP2;1基因在芹菜根、叶柄和叶片中均有表达,其中在叶片中的表达量最高,在根中的表达量最低,呈现比较明显的组织特异性。此外,AgPIP2;1基因受到高温、低温、干旱和盐等非生物胁迫的诱导,说明该基因可能参与芹菜抵御非生物胁迫的过程。本研究为进一步了解AgPIP2;1基因的功能及其在非生物胁迫中的作用奠定了基础。     

盐碱复合胁迫对白茎盐生草种子萌发的影响

为了解盐碱胁迫对种子萌发的影响，本研究以白茎盐生草(Halogeton arachnoideus)为研究对象，采用室内模拟试验，以盐分种类和盐浓度为控制因素，按照NaCl ? Na2SO4 ? NaHCO3 ? Na2CO3的顺序，以A (1 ? 1 ? 0 ? 0)、B (1 ? 2 ? 1 ? 0)、C (1 ? 9 ? 9 ? 1)、D (1 ? 1 ? 1 ? 1)、E (9 ? 1 ? 1 ? 9) 5种不同比例进行混合，共5个组别，记为A－E；每个组别分为6个浓度，共30个处理，研究盐碱复合胁迫对其种子萌发的影响。结果表明：随着盐溶液浓度的升高，种子发芽率、发芽势、发芽指数均呈下降趋势；将盐溶液中未萌发的种子转移到蒸馏水中后，种子可以不同程度地恢复萌发。经过回归分析得出，A－E的耐盐阈值依次为0.26、0.24、0.23、0.25、0.16 mol·L?1，耐盐极限值分别为0.65、0.62、0.62、0.60、0.52 mol·L?1；聚类分析得出，A－E的耐盐阈值依次为0.3、0.2、0.3、0.3、0.1 mol·L?1。对回归与聚类分析结果取均值，得出白茎盐生草种子萌发在盐碱复合胁迫下的耐盐阈值为0.234 mol·L?1，耐盐极限值为0.602 mol·L?1。盐分浓度对种子萌发的影响大于盐分种类。相较于碱性盐，白茎盐生草更耐受中性盐环境。     

Initial shapes of stress-strain curve of wood specimen subjected to repeated combined compression and vibration stresses and the piezoelectric behavior

This study investigated the relationship between the initial shape of the stress (σ)-strain (ε) curve of a Chamaecyparis obtusa wood specimen subjected to repeated combined compression and vibration stresses at various angles between the fiber direction and load direction and the piezoelectric behavior. The main findings of the study are: (1) the σ-ε curve became convex initially, and then the stress was proportional to the strain. The σ-ε curve had almost the same shape during both loading and unloading. (2) The σ-piezoelectric voltage (P) curve was nonlinear, with a maximal point or cusp on the curve, which had almost the same shape during both loading and unloading, as was also observed for the σ-ε curve. (3) The plot of the first derivative of the stress [dσ/dε (= σ′)] against ε was nonlinear. The σ′-ε and P-ε curves at various angles were fairly similar. (4) The stress at the maximal point (or cusp) of the σ-P curve decreased with an increase in the angle between the fiber direction and load direction. The tendency of the stresses was very similar to that of Young’s modulus and compression strength calculated from Hook’s law and Hankinson’s law, respectively.     

内应力释放对刨花板尺寸稳定性的影响分析

研究了热压过程中内应力的形成机理和板材内部应力状态,探讨了内应力释放对刨花板尺寸稳定性的影响,提出了减小内应力和提高尺寸稳定性的工艺措施.刨花板会发生变形,即尺寸不稳定,源于以下两个基本原因:(1)构成刨花板主体单元的木材有吸湿性;(2)刨花板在热压过程中产生了内应力即残余应力.刨花板内应力释放时,人们可以实实在在地感觉到,例如:刨花板热压结束后,卸板时板坯内会传出嘣、嘣、嘣的声音,或者是规整而无变形的刨花板在开料后会发现有翘曲变形出现.这就是残存在刨花板内部的应力在释放.本文根据木材传热传质的理论、应力松驰理论、相平衡理论对刨花板内应力形成机理和应力状态及内应力释放对刨花板尺寸稳定性的影响进行分析和研究,为生产提供理论指导.     

转MsLEA4-4基因拟南芥株系的耐盐性分析

为了深入研究紫花苜蓿（Medicago sativa）MsLEA4-4基因的抗逆性，本试验对前期获得的转MsLEA4-4基因的拟南芥（Arabidopsis thaliana）株系进行不同浓度盐胁迫处理，以验证MsLEA4-4基因在拟南芥植株体内的耐盐性。试验结果表明：盐胁迫后转基因株系的发芽率达到55%，比对照植株（Control plant，CK）高81%；转基因株系的鲜重、叶绿素含量均高于CK（P<0.05）；盐胁迫后转基因株系的存活率比CK提高75.0%~81.3%；盐胁迫明显抑制根系生长，但转基因植株的侧根数量比CK多4~5根（P<0.05）；盐胁迫后转基因株系体内的可溶性糖含量（P<0.05）和超氧化物歧化酶（P<0.01），过氧化氢酶（P<0.01），过氧化物酶（P<0.05）活性均高于CK，脯氨酸（P<0.01）和丙二醛（P<0.05）含量均低于CK。综上可得，MsLEA4-4基因参与了拟南芥体内的耐盐性调控，提高了转基因拟南芥对盐胁迫的耐受性。本研究为进一步探索MsLEA4-4在转基因紫花苜蓿盐胁迫中的功能及培育耐盐性紫花苜蓿品种提供依据。     

径向谐和激励下圆形隧道衬砌的动力稳定性

对径向谐和激励下圆形隧道的动力稳定性进行了研究，从动荷载下衬砌结构的振动方程出发，得到了隧道衬砌动力失稳临界频率计算公式，对可能影响隧道衬砌动力稳定性的因素进行了参数分析，探讨了系统参数，如地基土的性质、衬砌径厚比、外激励的性质以及系统的阻尼对衬砌动力稳定性的影响，计算结果表明：隧道周围土体的性质以及系统阻尼对衬砌的动力稳定性影响不大；相反，衬砌的厚度和外激励特性对衬砌的动力不稳定区域影响较大     

Detecting interactive effects of N fertilization and heat stress on maize productivity by remote sensing techniques

The objective of this study was to compare the performance of two different remotely sensed techniques in detecting the effects of terminal heat stress and N fertilization on final maize aerial biomass (AB) and grain yield (GY). The study was conducted under field conditions for two consecutive growing seasons. Six N treatments combining three doses [0, 100, 200 Kg N ha⁻¹] and two timings [at V4 and at 15 days before silking] were applied. Within each N treatment three heat treatments were applied (pre-flowering, post-flowering and the control treatment at ambient air temperature). Remote sensing measurements were taken with a multispectral band camera to measure the normalized difference vegetation index (NDVI) and a digital Red/Green/Blue (RGB) camera to measure the normalized green red difference index (NGRDI). Both indices failed to predict the GY of pre-flowering heat-treated plants due to grain set establishment problems that could not be detected by vegetation indices which are designed to capture differences in green canopy area. In contrast, both the NGRDI and the NDVI correlated positively with GY and AB in the control heat treatment and to a lesser extent in the post-flowering heat treatment. Under the control heat treatment, the NGRDI exhibited higher correlations with AB and GY than the NDVI across the N fertilization treatments. Since the NGRDI is formulated based only on the reflectance in the visible regions (VIS) of the spectrum (Green and Red) without dependence on the near infrared regions (NIR), it performs better than the NDVI. This is because it overcame the reported saturation patterns at high leaf area index and was more efficient at capturing even small differences in leaf colour (chlorophyll content) due to the different applied N treatments. Also, the NGRDI seemed to be a more seasonally independent parameter than the NDVI, which is more affected by temporal variability within the field, and thus the NGRDI predicted AB and GY better than the NDVI when combining the data of the two growing seasons.     

多点成形压力机的反复成形技术研究

基于对多点成形过程的分析,推导了反复成形过程中基本体对板材的作用力分布,得到了基本体作用力与成形力矩的关系。从理论上分析成形件内部残余应力的分布,解释了反复成形法减小回弹的机理,讨论了反复成形法对成形零件质量的影响。