竹材弦面纵向切削的研究

研究了竹材弦面纵向切削的3种切削方式(单劈刀切削、单刨刀切削及并列式双刨刀切削)及单刨刀切削时的切削阻力,结果表明:对竹材采用劈或刨的切削方式,均可进行弦面纵向切削并能获得质量较好的竹蔑。竹材的节间、节部、切削厚度、含水率及切削速度等因素对切削阻力均有不同程度的影响。节部切削阻力明显高于节间切削阻力;切削阻力随切削厚度的增大而增大,两者成线性关系;含水率增大时,节间切削阻力减小,而节部切削阻力变化不大;切削速度增大时,节间切削阻力基本上是下降的,而节部切削阻力是增大的。     

筒式结构拆除的力学分析

根据力学原理，分析讨论了钢筋混凝土筒式结构定向倾倒的切口高度和切口角度．     

笃斯越桔硬枝扦插繁殖技术研究

采用笃斯越桔硬枝扦插,用生根剂处理插穗,并在不同的基质上进行扦插试验,结果表明:笃斯越桔硬枝扦插用河沙作为基质最好,生根剂ABT处理的插穗生根率最高。     

Application of acoustic Doppler current profiler combined with a scientific echo sounder for krill Euphausia pacifica density estimation

ABSTRACT:   An application of the acoustic Doppler current profiler (ADCP, 153.6 kHz) in combination with a scientific echo sounder (EK60, 38 and 200 kHz) was investigated to estimate the density of krill Euphausia pacifica . The acoustic backscattering strength from sound scattering layers was compared with biomass estimates from midwater trawls. Euphausia pacifica was targeted among mixed species populations in the sound scattering layer in the offshore Funka Bay area of Hokkaido, Japan. The frequency characteristics of acoustic backscattering by krill were calculated using a distorted wave Born approximation scattering model at three frequencies. Krill aggregations identified from the EK60 data were extracted as the mean volume backscattering strength difference between two frequencies. They were then used to identify similar aggregations in the ADCP data by matching observation times and depths for the two methods, which were applied simultaneously. Results from the comparison of the mean volume backscattering strength and the density calculated from the ADCP and EK60 showed that ADCP can be used to measure density and spatial–temporal distribution of krill aggregations. Current speed and direction at the study site were found to be 16.1 cm/s and 187.0°, respectively, and krill speed and direction (including the current component) were found to be 19.8 cm/s and 172.2°, respectively. Based on the ADCP data, the net speed and direction of the krill aggregations were found to be 5.9 cm/s and 128.0°, respectively.     

木瓜剖分原理研究及新机型设计

针对我国目前对木瓜剖半设备研究较少,剖切方式不合理,切割效果差等问题,设计开发了新型木瓜剖半机。该机切割方式选用滑切切割的方式,由运料系统、切割系统、出料系统组成,设计合理,结构简单。为此,计算了滑切角、切割角等主要切割参数,并给出了新型剖半机的主要技术参数。试验表明:该机切割效果好,能够有效提高生产效率。     

Residue management for reducing evaporation in relation to soil type and evaporativity1

Abstract. Usual residue-management options are to remove the residue, use it as mulch with or without undercutting or to incorporate it into the soil. While the role of surface mulch in evaporation has been widely studied, the information on the effect on evaporation of mulch with undercutting or residue incorporated into soil, particularly in relation to soil type and evaporativity (E_o) is lacking. We studied the effect of wheat straw used in various ways on the course of evaporation loss from soil columns with three soils at Ludhiana, India and one soil at Bushland, Texas, USA, under two E_o's Energy-limited evaporation rates under mulch (E_om) followed the soil-specific relation E_om/E_o= a e^(bRes+cEo), where Res is residue rate t/ha and a, b and c are constants; E_o, is expressed in mm/d. In an effort to model the total evaporation (CE) during the energy-limited stage ‘U’ was obtained from appropriate CE versus time curves and (CE-U) was regressed over (t - ti)^0.5 to obtain the slope ‘α’ (Ritchie 1972) for the soil-limited evaporation stage. The observed ‘U’ was independent of mulch rate and E_o but was strongly affected by soil type, Values of ‘α’ decreased with increase in mulch rate and decrease in E_o and coarseness of soil. The otherwise short lived benefit of evaporation reduction with mulch per se, which peaked after a few days was maintained when residue was mixed with soil at the stage when evaporation reduction reached a maximum; this benefit continued for several weeks. Cumulative evaporation values computed from ‘U’ and ‘α’ agreed closely with the observed values under straw mulch for loamy sand and clay loam soils and for ‘undercut’ and ‘residue mixed’ treatments on all soils regardless of E_o, and for all situations under small E_o. However, for sandy loam and silt loam soils under E_o of 10 mm/d, the modified square root of the time function of Jalota et al. (1988) gave a better fit.     

我国价格体系改革趋势初探

本文以我国国民经济系统与河南省经济子系统的同构性为基础,利用河南省1987年投入产出表,计算出诺依曼最优生产强度和与之相应的最优价格,进而对照现行价格,提出了我国价格体系改革走向的基本构想,并对其合理性、可行性进行了初步研究。     

浅谈建立郑州市道路路面养护管理系统

路面管理系统是通过对路面运行状况、使用性能、使用周期、进行对比、分析，预测路面管理的最佳养护预算投资并在最佳养护经济投资条件等各种因素限制下，寻求道路养护管理最佳战略决策。     

节能日光温室光照强度的分布及其变化

在充分考虑了温室结构和植株生长影响的基础上,对日光温室光照强度的变化规律进行了研究,得到的主要结论如下:冠层上部辐射强度的南北差异比东西差异大;冠层下部光照条件东西差异明显,南北差异不大。总体上讲,辐射强度上下差异比南北差异明显。     

pH及阳离子浓度对柞蚕蛹蛋白溶解性的影响

对不同pH及阳离子浓度下柞蚕蛹蛋白的溶解性进行了研究。结果表明,柞蚕蛹蛋白的等电点pI为4.2~4.5。测定不同的阳离子对其溶解度的影响顺序为Zn2+>Ca2+>Mg2+>Na+,随着阳离子浓度的增加,蛹蛋白的溶解性增加,当离子浓度超过1.0 mol/L时,其溶解性则降低。