PWM变量喷雾系统动态雾滴分布均匀性实验

由于PWM变量喷雾作业过程中喷头不连续作业,喷雾的均匀性特别是喷雾机运动方向上的均匀性较难控制,为此通过高速电磁阀、不锈钢压力罐、压力传感器、气泵、调速输送带等构建了一套动态PWM变量喷雾实验平台,并对该平台动态喷雾雾滴分布特性进行实验研究。采用水敏试纸作为获取动态雾滴分布状态手段,通过图像处理技术以区域内雾滴覆盖率的变异系数作为动态雾滴分布均匀性判定指标,评估了在不同PWM控制信号频率、不同PWM控制信号占空比及不同喷雾压力下的单个喷头动态雾滴分布均匀程度。经实验表明,变异系数随控制信号占空比的增大而减小,控制信号频率对动态喷雾雾滴分布均匀性有较大影响,变异系数随控制信号频率增大而减小,喷雾压力对变异系数影响较小,喷雾压力越大变异系数越大。     

等离子体脉冲荷电喷雾装置

设计了一套用于荷电喷雾的高压脉冲电源和等离子发生环 ,详细介绍了脉冲电源电路、电极结构和脉冲荷电喷雾系统 ,分析了脉冲电源的荷电原理 ,检测了系统的荷质比。理论分析和试验结果表明 :在同样试验条件下 ,脉冲电源优于普通直流高压电源 ,具有起晕电压低、能耗省、工作平稳、结构紧凑等特点 ,可靠、经济、实用     

基于高压电技术的烟气脱硫研究与应用进展

分析与评述了国内外基于高压静电技术的烟气脱硫研究与应用进展,介绍了几种以高压电技术为基础的烟气脱硫新技术--电子束烟气脱硫、脉冲电晕等离子法脱硫、荷电干法烟气脱硫和荷电喷雾烟气脱硫技术;并且分析了这几种烟气处理技术的作用原理、特点和发展现状,展望了其应用前景.     

国产大型喷灌技术的发展与应用分析

喷灌机是由水泵、动力机、输水管道及喷头等组成的喷灌装置。其由田间渠道或管道供水,按预定的顺序移动工位,向农田喷水。大型喷灌机带有驱动装置或由拖拉机牵引,带有供水管道,且装有多个喷头,因而作业面积大,适合于各种作物的浇灌。为此,评述了就我国大型喷灌机技术的发展历程,评价了大型喷灌机的技术水平,分析推广应用前景作,指出了推广应用中需要注意的事项。     

脉宽调制型变量喷雾系统雾量沉积分布

通过实验和理论分析建立了雾量分布模型,研究了雾量分布规律。研究表明:喷杆方向沉积变异系数在两喷头之间出现最低,而在两喷头正下方出现极高值;行驶方向的沉积变异系数沿着一定规律周期性变化,其周期与占空比相关;在相同压力的情况下,同一喷头的行驶方向及喷杆方向沉积变异系数的峰值均随着车速的提高而上升,随占空比的上升而下降;在研究范围内(40~60cm),变异系数的峰值随喷头高度的升高而降低;若车速和占空比均相同,110°扇形喷头的雾量分布较80°扇形喷头在时空方向上都更加均匀。     

400克/升氯氟醚菌唑悬浮剂对香蕉叶斑病的防治效果

通过大田试验研究了400克/升氯氟醚菌唑悬浮剂防治香蕉叶斑病效果及其对香蕉产量的影响。研究结果表明,分别以20毫升、13.3毫升、10毫升400克/升氯氟醚菌唑悬浮剂兑水60公斤分3次喷雾施药,第二次施药后14d后对香蕉叶斑病防治效果在60.43-66.52%,第三次施药后14d后对香蕉叶斑病防治效果在75.72-80.72%,并对香蕉的单株产量有明显增产效果。其中尤以20毫升400克/升氯氟醚菌唑悬浮剂兑水60公斤剂量喷雾处理的效果最好。     

喷头和施药液量对水稻植株上农药沉积和药剂防治效果的影响

为明确喷头及施药液量对水稻植株上农药沉积及药剂防治效果的影响,采用丽春红-G示踪法测定了4种喷头ST11001、ST11002、TR8001、TR8002在不同施药液量条件下喷雾农药在水稻植株上的沉积分布特性,并比较了4种喷头施用相同剂量的40%氯虫苯甲酰胺·噻虫嗪WDG对水稻纵卷叶螟Cnaphalocrocis medinalis和褐飞虱Nilaparvata lugens的防治效果。结果表明,选择ST11002和TR8001喷头,在施药液量300 L/hm~2条件下喷雾,单株水稻上的丽春红-G沉积量分别达到27.55μg和28.16μg;选择ST11001和TR8002喷头,在施药液量900 L/hm~2条件下喷雾,单株水稻上的丽春红-G沉积量仅分别为12.27μg和14.86μg。喷头和施药液量的改变不影响水稻植株上农药沉积分布特性,均为上层沉积量中层沉积量下层沉积量。当施药液量从300 L/hm~2增加到900 L/hm~2,4种喷头ST11001、ST11002、TR8001、TR8002喷雾在水稻基部的雾滴密度分别增加了8.21、8.54、7.79和9.69倍;但在相同施药液量下,4种喷头在水稻基部的雾滴密度没有显著差异。同一剂量下,喷头和施药液量不同组合的防治效果间差异显著。表明针对稻田不同防治对象,选择合适的喷头及施药液量将有助于提高农药沉积及防治效果。     

Modelling optimal timing and frequency of insecticide sprays for knockdown in preparation for other control measures

A modelling investigation was conducted into optimizing the number of sprays and inter-spray interval to reduce an insect population to a low level, for example, prior to pheromone trapping or the release of sterile males. The model population was age-structured and density-dependent. If spray mortality is 100% for each spray, then the ideal spraying schedule is easily determined from the durations of the various life stages. For spray mortality of less than 100%, a simulation was used to determine optimal spraying schedules. Relative length of the larval period, fertility rate and age to first oviposition were found to be the most important biotic parameters for this determination. Their importance is magnified as spray mortality decreases. The stage targeted by sprays and the percent mortality caused by each spray are also important in determining the required number of sprays. Using medfly (Ceratitis capitata Wiedmann) biotic parameters as an example when the spray targets adults, it appeared that neither the stage at which density-dependent mortality takes effect, nor the form of the adult survivorship curve are important in determining the optimal spray schedule.     

Evaluation of lipid spray beads for the delivery of water-soluble materials to a marine suspension-feeder, the Manila clam Tapes philippinarum (Deshayes 1853)

We describe the development and evaluation of a new microparticle for delivering low-molecular weight, water-soluble materials to suspension feeders. Spray beads successfully incorporated materials dissolved in an aqueous phase or as dry particulate, within a triacylglyceride bead composed of tripalmitin, 600 mg g⁻¹ tripalmitin/400 mg g⁻¹ triolein, or 600 mg g⁻¹ tripalmitin/400 mg g⁻¹ fish oil.
Riboflavin was successfully incorporated (up to 44 mg g⁻¹ lipid) and retained (up to 98% over 24 h in seawater) as dry particles in all three mixtures of lipid. Aqueous oxytetracycline hydrochloride or polymeric dye were incorporated (45.6 mg g⁻¹ lipid and 18.1 mg g⁻¹ lipid, respectively) and retained best (99% and 94%, respectively) in spray beads composed of tripalmitin. The addition of triolein or fish oil to the lipid bead reduced incorporation and retention efficiencies for aqueous core materials by up to 75%.
Manila clam seed readily ingested and digested lipid microparticles, spray beads and lipid-walled microcapsules. Microparticles composed of tripalmitin were excreted with their payloads intact. Intact microparticles composed of 600 mg g⁻¹ tripalmitin/400 mg g⁻¹ fish oil were largely absent in faecal strands suggesting successful release and delivery of microparticle contents to clams.
Spray beads composed of tripalmitin softened with 400 mg g⁻¹ fish oil represent an effective microparticle type for delivering low-molecular weight, water-soluble materials to aquatic suspension feeders.