打结器支架精铸毛坯误差分析与五轴数控加工方法

针对打结器支架铸造毛坯存在误差、支架结构复杂、难以加工成型等问题,为了减小支架毛坯铸造误差对加工质量的影响,基于三维扫描技术对打结器支架毛坯进行逆向检测与分析,得到同一批次铸造支架毛坯的误差分布规律。通过推导不同空间坐标系下的轴孔中心坐标变换规律,提出一种支架轴孔加工位置偏离理想位置的调整方法。针对打结器支架的5个空间交错轴孔和1个凸轮曲面,设计了打结器支架的专用夹具,制定了五轴数控加工工序,通过一次装夹可完成5个空间交错的轴孔和凸轮曲面的加工。将加工成型的支架和其他零部件组装成打结器,进行了方草捆打结试验,结果表明,打结器支架上各轴孔的相对位置与角度关系准确,打结动作精准、可靠,支架加工成品率为99%,方草捆成结率为100%。     

矩形薄壁侧堰水力特性试验研究

侧堰作为一种量水设施,精度较高、结构简单、安装和拆卸方便,较易在灌区应用和推广,有很大的研究价值。对不同宽度和高度的矩形侧堰在缓流条件下进行了试验,分析了各工况下矩形渠道侧堰上、下游水面线、能量分布、流量系数等水力因素。结果表明,主渠道侧堰段能量基本保持不变,符合De Marchi的恒定能量假定;主渠道靠近侧堰边壁、中心线以及另一边壁三处的水面波动程度不同,说明侧堰对堰前水流产生影响;基于De Marchi假定和无量纲分析原理得到的流量公式最大相对误差均在±10%以内,满足灌区量水精度要求。     

陕西省部分小麦栽培品种高分子量麦谷蛋白亚基组成及其与品质关系

本研究以36个陕西省主要栽培品种为材料,利用SDS-PAGE方法分析了高分子量麦谷蛋白亚基组成,并对其SDS沉淀值进行了测定,分析了高分子量麦谷蛋白亚基组成与代表面包烘烤品质的SDS沉淀值间的关系.结果表明:Glu-1位点存在着广泛的等位基因变异,在所分析的36个品种中,Glu-A1位点亚基1出现频率最高,为63.9%;Glu-B1位点等位基因变异最丰富,其中亚基7 8和7 9出现频率最高,其次为亚基14 15;Glu-D1位点亚基组成以2 12为主;对各位点品质评分与SDS沉淀值的简单相关分析结果表明各位点品质评分与SDS沉淀值均存在着显著或极显著相关关系,各位点影响大小依次为Glu-D1＞Glu-A1＞Glu-B1;Glu-1品质评分与SDS沉淀值极显著正相关.     

微生物发酵床猪舍空气微生物种群结构的研究

为了研究微生物发酵床猪舍空气微生物的组成,采用自然沉降法对猪舍空气微生物进行收集,利用16S rRNA序列分析及形态观察确定微生物的分类,揭示猪舍空气微生物的多样性。从猪舍空气中共分离到细菌60余株,经过16S rRNA基因序列的同源性比对,最终确定27个代表菌株进行后续分析。分析结果表明,27株细菌中包含芽孢杆菌属14个种（51.9%）,假单胞菌5个种（18.5%）,葡萄球菌4个种（14.8%）,苍白杆菌属、类芽孢杆菌属、赖氨酸芽孢杆菌属及单胞菌属各1个种;27株细菌中包含5种条件致病菌,6种有机物降解菌。采用SPSS分析将猪舍空气微生物按采集地点明显聚成6类：仅分布于猪舍下风处的菌、仅分布于猪舍上风处的菌、仅分布于猪舍外的菌、猪舍上风和下风处共有菌、猪舍下风处和猪舍外共有菌及3处共有菌。对猪舍空气微生物空间分布的研究显示,猪舍下风处微生物种类较多,有20种,多于猪舍上风处和猪舍外部,其中15种为下风处特有种。由于微生物以气溶胶的形式存在,猪舍内相邻位置具有相似的微生物组成。以上研究结果表明,微生物发酵床猪舍空气微生物种类丰富,且微生物分布与风向相关。     

利用无机膜分离技术降低大米饮料沉淀率的研究

大米饮料是目前国内饮料厂家密切关注和开发的产品。大米饮料因采用富含淀粉质的大米作为原料,经水解液化后制备而成,货架期内极易发生沉淀分离现象,严重降低了产品的商品价值。采用无机膜分离技术处理大米饮料,选择合适处理工艺及参数,可除去大米饮料中微米级颗粒。研究结果表明,无机膜处理能有效解决大米饮料的沉淀问题,工艺技术稳定可靠,可取代离心分离等净化技术。     

Application of Chitosan to Technology of Clarification for Chinese Traditional Medicine Extraction

As the product of natural macromolecule chitin deacetylating, Chitosan is linear macromolecule carbohydrate and is widely applied to medicine, chemical industry and environmental protection, etc.. The distribution, general properties and clarifying principle of chitosan, and the application of chitosan to the clarification of Chinese traditional medicine extraction are described . Compared with ethanol sedimentation process, the chitosan clarification is a safe, of innocuity, cheap and fine clarifying process. Chitosan clarification process can replace the conventional ethanol sedimentation process as the method of fining Chinese traditional medicine extraction and preparation. The feasibility and the problem are discussed. And the advice for future researching orientation is put forward.     

CYLINDRICAL BENDING PROBLEM OF RECTANGULAR PLATES STIFFENED ON ONE SIDE ALONG ONE DIRECTION WITH ELASTIC SUPPORTS AND TENSILE FORCES

On the basis of the calculated results of accurate analytic solution of stiffened rectangular plates,the general equations of cylindrical bending of the plates with tensile forces are established for engineering practice.Its solution combining with engineering problem is given for the special defor-mation conditions of elastic supports.In the paper,the numerical example is given and compared with references,it shows that the results are available.     

Research on Sedimentation Technique of Tube Settler withRectangular Cross-section and Vertical Adhesive Interface

A new type of tube settler with rectangular cross-section and vertical adhesive interface in the tube module is proposed.The tube module by this kind of tube settler has flat top and bottom faces.Experiments show that the tube settler with rectangular vross-section and vertical adhesive interface has the advantages of better sedimentation performance,less material censumption for its construction and no flow transitional section from turbulent flow to laminar flow in the inlet part of the tube of which the whole length takes part in solid-liquid separation.     

Effect of Two Pretreatment Techniques on Preventing Membrane Fouling

Ultrafiltration membrane was used to filter the Yangtze River water by powder activated carbon (PAC) pretreated, such as Tai Lake water by coagulation-sedimentation pretreatment. The changes of organic polar content were compared in each process. Combined with the scanning electron microscope(SEM) photographs of the membrane, the mechanism of slowing down membrane fouling by PAC and coagulation-sedimentation pretreatment was studied. The results showed that hydrophobic organic compounds were the main factors of membrane fouling, while hydrophilic organics had less impact. When the dosing quantity of PAC filtered by ultrafiltration membrane was 20 mg/L to pre-treat the water samples of Yangtze River, and that of polyaluminium chloride was 25 mg/L for the pretreatment of Tai Lake water samples, the flux could be recovered effectively after backwashing compared with filtering the two raw water directly. The cake layer formed on the surface of the membrane was looser after pretreatment, and could be discharged easily by periodic backwashing, The cake layer could prevent hydrophobic organic matters deposit on the surface of membrane directly, which will slow down the membrane fouling and improve the chemical safety of the membrane effluent.     

Natural regeneration on planted clear‐cuts in boreal Sweden

Natural regeneration was registered on 97 clear‐felled and scarified sites in northeastern Sweden ten growing seasons after planting. On each site, three fix plots were laid out at planting and the planted seedlings were mapped. Ten years later all healthy non‐planted seedlings were registered in an anulus of size 15.7 m². Non‐planted seedlings were also observed in four 4 m² squares on each fix‐plot to estimate the zero‐square frequency. Species were classified as Pinus sylvestris, L., Picea abies (L) Karst. and deciduous species (Betula pendulajpubescens Roth./Ehrh., Populus tremula L., Alnus incana (L) Moench.). On average, 7 133 non‐planted seedlings ha^‐1 were found, of which 29% were conifers. Among the conifers, 71% were P. abies. More than 2 500 conifer non‐planted seedlings ha^‐1 were found on 27% of the plots. The number of non‐planted seedlings was correlated to the presence of neighbouring seed‐producing stands within 100 m and decreased with rising altitude. Pinus sylvestris seedlings were more frequent on dry soils while the deciduous seedlings were more frequent on wet sites. In the 4 m² squares, the zero‐square frequency was 29% if both conifers were and deciduous seedlings were considered and 63% if only conifers were considered. Mean height of the tallest seedling per species and square was 62 cm for P. sylvestris, 42 cm for P. abies and 107 cm for the deciduous seedlings. Key words: Alnus incana, Betula, broad‐leaves, deciduous, Norway spruce, Picea abies, Pinus sylvestris, Populus tremula, reforestation, Scots pine.