基于定向定量堆放的马铃薯收获机设计

在研究小型马铃薯收获机的基础上,设计了一款能根据收集薯块质量往特定方向堆放的马铃薯收获机,主要由挖掘装置、输送装置及定向定量堆放装置等组成。在马铃薯收获机的后部设计一个四分区临时集薯器,能根据所收获马铃薯的质量来打开集薯器,将收集的马铃薯向中间或者一侧堆放,从而实现了马铃薯的连续挖掘及收集薯块的定向定量间隔堆放,可在较大程度上降低人工捡拾的工作量,同时避免拖拉机碾压伤薯。     

滴灌水肥管理对日光温室黄瓜产量和品质的影响

采用田间试验,研究滴灌系统运行方式和施肥频率对黄瓜产量、品质的影响。结果表明:施肥频率对黄瓜的生长、产量和品质的影响显著,在开花期与采收期,提高施肥水平能促进植株株高和叶片数的增加,产量和品质随施肥频率的增加而增加。因此,从提高产量和品质的角度看,施肥频率取两周1次较为适宜,滴灌施肥灌溉过程中的施肥时段应尽量前移。     

农业机械化推广模式创新分析

随着农业生产规模的扩大和机械化水平的提高,人们在进行农业生产的时候,已经普遍接受并采用机械化的生产模式,文章就农业机械化发展出现的问题进行了介绍,并提出了在我国进行农业机械化的推广的具体措施。     

覆盖方式对旱地小麦花后旗叶抗氧化生理及粒重形成的影响

于2017—2018年和2018—2019年,在西北中部旱作雨养农业区以冬小麦‘康庄974’为试验材料,设秸秆带状覆盖(SM)、地膜覆盖(PM)和无覆盖对照(CK)共3个栽培处理,分析不同覆盖方式对小麦灌浆期土壤水分和温度及抗氧化能力的影响,探讨花后干物质积累量和粒重形成的关系。结果表明,随生育期推进,花后旗叶相对含水量(RWC)逐渐降低,丙二醛(MDA)含量逐渐升高,且PM较SM降、升幅度明显。与CK相比,覆盖显著提高花后旗叶抗氧化酶活性,增加渗透调节物质含量;开花时间越长,SM抗氧化酶活性升高的幅度越大,而PM主要提高花后7 d旗叶抗氧化能力。SM和PM的粒重分别较CK增加14.3%和19.1%(P<0.05)。相关分析表明,土壤水分(SW)是影响旗叶生理活性的关键因子,提高SW,有利于增加RWC(r=0.84^**),从而提高旗叶抗氧化能力,其中RWC和抗坏血酸酶(ASA)活性呈极显著正相关关系(r=0.82^**);ASA活性和脯氨酸(Pro)含量呈极显著正相关关系(r=0.94^**),和MDA含量呈极显著负相...     

稀燃汽油机瞬态空燃比的滑模-神经网络控制

提出了稀燃汽油机空燃比滑模-神经网络控制方案,采用滑模变结构控制对稀燃工况的空燃比进行反馈控制,采用神经网络实现对进气量的精确预测和油膜动态特性的前馈补偿,进而实现对稀燃发动机瞬态空燃比的精确控制。采用自行开发的电控系统,在一台稀燃发动机上进行了瞬态空燃比实验。实验结果表明:节气门急速变化时空燃比超调可以控制在1个空燃比单位以内,调整时间不超过3s;转速越低,节气门变化越剧烈;空燃比超调越大,调整时间越长。     

环境污染对农业生态系统服务功能影响

农业生态系统服务功能是农业生态过程和人类活动所形成的人类赖以生存的自然环境条件与效用. 城市污染物排放增加, 农业化学品污染加重, 农村畜禽粪尿污染成灾以及乡镇企业污染发展影响了农业生态系统有机质生产, 降低了农业产品品质, 减弱了土壤生态过程, 破坏了生物多样性, 减弱了气候调节与减灾功能, 减少了动物传粉与有害生物控制效应七项生态服务功能. 遏止环境污染是保护农业生态系统服务功能的关键.     

Nonlinearity of Electronic Throttle and Its Control

This paper introduces the development of the electronic throttle control system (ETCS) , the structure and the principle of the system are also involved. After analyzing the nonlinearity problem existing in the mechanical structure of the system, a mathematical model of the ETCS is built up. Then three controllers (PID controller, Fuzzy controller, sliding mode controller) were designed and simulated in the matlab simulink. The result indicates that the PID controller has an overshoot,but the Fuzzy controller and the sliding mode controller can settle the nonlinearity problem better.     

Discussion on Second-order Analysis of Variable-Section Beam-Column

In this paper, based on the discussion of orthogonal decomposition method for the buckling mode of unsymmetrical structure, taking the variable-section beam-column as an example, a simple and direct method of the second order analysis is presented. In the new method, the conception of enlargement coefficient brought forward by Timoshenko is developed. To begin with the curvature of the variable-section beam-column, the linear equations are set up. With their solution, a group of orthogonal buckling mode can be obtained. The primary deflection can be decomposed to a group of homomorphic deflection similar to buckling mode. Then, the group of deflection is multiplied by corresponding enlargement coefficient and plus the result, finally, the second-order total deflection can be obtained.     

Nonlinear Finite Element Analysis of RC Deep Flexural Simply Supported Beams Using Disturbed Stress Field Model

A nonlinear finite element analysis of 4 RC deep flexural simply supported beams with the program VT2 is presented. Crack development and failure modes , longitudinal reinforcement strain distributions and load -deflection curves were compared as a result in order to evaluate the validity of the disturbed stress field model to analyse such deep simply supported beam.