鹅掌楸种源材性遗传变异与选择

在鹅掌楸两个种及其杂种多地点７年生种源试验林中,随机抽取３块试验林共２８２株样本,分别遗行木材基本密度（ＢＤ）和纤维长度（ＦＬ）的测定分析,在分布型拟合与精度分析的基础上,进行一般线性方差模型分析,结果为：中国鹅掌楸种源间ＢＤ和ＦＬ均差异显著（a=0.05),５个北美鹅掌楸种源间ＢＤ和ＦＬ未达到显著差异,地点间差异及种源与地点的交互作用不显著,平均值Ｔ检测表明中国掌楸与北美鹅掌楸两种间ＢＤ和ＦＬ均不存在显著差异,鹅掌楸的ＢＤ总均值为0.397g/cm^3,ＦＬ总均值达１.603mm,属于中小密度,长纤维或近长纤维树种,差异分析揭示了种内差异是掌释属的主要变异来源,种内种源间存在选择的遗传基础,性状遗传相关分析认为,鹅掌楸ＢＤ和ＦＬ之间相互不密切（r=0.157),两本材料状与各生长因子间相关亦不密切,说明他们之间基因连锁不紧密,可独立选择。BD种源广义遗传力为H^2BD=0.65,受遗传控制较强,ＦＬ为Ｈ^FL=0.29,受遗传控制中偏弱,两性状年－年间遗传相关密切,在上述分析结果的基础上方３种标准进行了鹅掌楸属材料种源选择,其中,在“强度选择”条件下,选出ＢＤ优良的种源为庐山和桑植,ＦＬ优良的种源为浏阳和赣武夷,均为中国掌楸种源,北美种源虽然与中国种源在总体上不存在明显差异,但多数处于中等水平上,对照杂种夫性系ＢＤ和ＦＬ的均超过鹅掌楸性状总均值,但未超过最好的种源。     

粘钢加固技术的设计与应用

粘钢即在被加固构件表面粘贴钢板，籍以提高其承载能力，目前粘钢技术已在实际工程中得到广泛应用，技术日趋成熟，粘钢有施工简便、工期短、占用的空间小等优点；本文根据施工经验提出施工方法，以利在实际加固当中取得较好的经济效益。     

The Weighted Ideal Point Method and Its Application in Forest Harvest Regulation

本文通过对理想点法进行分析，认为该法取不同的ｐ值代表决策者对不同目标的偏爱程度；但ｐ值过大模型求解比较困难，故实际应用时ｐ值取较大的值并不现实．为进一步突出决策人对不同目标的偏爱程度，作者对理想点法进行改进，引进了各目标的权重，提出了加权理想点法．与前者比较，它进一步突出了不同目标对决策结果的影响，使决策结果更符合决策者的愿望，便于在生产中实施．通过用该法对山西省千秋沟林场某经营类型进行收获调整，表明用该法进行森林收获调整，到调整期末龄级结构基本达到完全调整林状态，且可将决策者对不同目标的要求落实到合理水平上．     

The method for designing the profile of forest roads supported by genetic algorithm

This study examines a method for designing an optimum profile of a forest road in a short matter of time. In this method, a genetic algorithm (GA) searches for points where the gradient changes and dynamic programing (DP) designs the longitudinal slope. This method can be applied to the ground heights of an actual forest road. The evaluation function of the DP assesses the total expenditure. The inverse of this function is the fitness function. Crossover and mutation are operators of an evolution simulation of a GA. They are each repeated 20 times and 420 profiles are designed and assessed, all within about 10 min. A comparison of the profile designed by the GA with that of an actual forest road shows only one section where the formation level differed substantially. Overall, both profiles seem to show a high degree of correspondence. From this result, we believe that the profile designed by the GA is best, or the one of the best. A conventional method takes about 65 h to calculate all changing points of gradients. However, by using the GA, the calculation time was reduced to about 1/389 that of the coventional method, showing that the method which uses the GA through the profile design is very useful.     

银木的光合与水分生理特性的研究

银木(Cinnamomum septentrionale Hand.Mazz.)系樟科樟属的常绿乔木,主要分布在年平均气温14℃,降水量800 mm以上的四川、陕西南部、甘肃南部、湖南等地区,是自然分布最北面的樟科植物.该树种系典型的北亚热带树种,对水、热条件的要求低于其它樟科植物,既能耐-10℃的低温,又能耐干旱[1].银木树皮灰色、光滑,叶近革质,互生,椭圆状、倒圆状披针形,具有较好的观赏性和较高的开发价值,在湖南、四川等地已人工栽培多年,形成特色鲜明的城市行道树.     

鸟类羽被防水性能的形态学基础

提出用水-羽毛接触点密度(Dp)的指标来描述鸟类廓羽表面的防水性能。29种鸟类胸部廓羽的检测表明,除了极少数物种以外,陆禽的Dp较小,涉禽和潜水鸟类的Dp居中,而游禽的Dp较大。这表明鸟类通过羽毛微观结构的变化来使羽毛具有相应水平的防水性能。因此,Dp是一个连接羽毛结构和功能的指标,对鸟类的适应性进化的研究具有重要意义。图3表1参9。     

不同种源翅荚木的抗寒性

以5个种源的翅荚木叶为材料,采用叶片离析法和石蜡制片技术观测叶片结构特征、电导率法测定其半致死温度、差示热量扫描仪测定其过冷点温度,并结合田间试验分析不同种源翅荚木苗期的抗寒性及其与叶片结构的关系.结果表明:湖南通道翅荚木种源抗寒性最强,苗期在湖南株洲无冻害,在浙江丽水冻害率为4.83%,极显著低于其他种源;其叶片半致死温度为-5.34 ℃,过冷点温度为-15.04 ℃,均低于广东翁源和广西忻城种源. 不同种源翅荚木叶片细胞结构紧密度(CTR)和疏松度(SR)与种源的抗寒性有一定的关系,CTR值越大、SR值越小,种源的抗寒性越强.     

桂林岩溶石山阴香种群的空间分布格局

通过野外调查,选取6块有代表性的样地,采用点格局分析方法研究了阴香种群的空间分布格局。结果表明,6块样地中,Q1和Q5样地阴香种群多数尺度上表现为集群分布,Q2和Q3以随机分布为主,Q4和Q6样地少数尺度上为集群分布,多数尺度上呈随机分布。阴香种群的空间分布格局与物种本身的繁殖特性、生境条件以及种内种间竞争等密切相关,由岩石的覆盖而形成的小环境对种群的分布格局类型有影响。点格局分析法较好地体现了不同尺度下阴香种群的分布格局特征。     

Natural abundance N in soil and litter across a nitrate-output gradient in New Hampshire

Stable isotopes of nitrogen are potentially a valuable tool for regional assessments of nitrogen saturation because they provide an integrated measure of the past nitrogen cycling history of a site. We measured δ¹⁵N of soil and litter, as well as net nitrification potential, at three sites across a nitrate-loss gradient in the White Mountains, New Hampshire to test the hypotheses: (1) that δ¹⁵N in soil and litter increase across a spatial gradient of nitrate loss; and (2) that δ¹⁵N in soil and litter is elevated when nitrification is elevated. δ¹⁵N was found not to vary significantly among the three sites. Patterns of leaf litter and forest floor δ¹⁵N, however, were strongly influenced by species composition in individual plots. Beech litter had significantly higher δ¹⁵N than yellow birch, sugar maple, and red maple. The conifer-dominated plots had significantly lower δ¹⁵N in both the organic soil horizons and in litter than did the hardwood-dominated plots. When we adjusted for spatial heterogeneity in mineral soil δ¹⁵N values by using an enrichment factor, δ¹⁵N_foliar − δ¹⁵N_Bs, in place of absolute soil δ¹⁵N values, a positive relationship was found with net nitrification for hardwoods. δ¹⁵N may also be a useful tool for evaluating species differences in nitrogen cycling and nitrogen uptake. The distinct pattern we observed of decreasing δ¹⁵N across the continuum from hardwood-dominated to conifer-dominated sites may suggest that local drivers (for example, nitrification rate) regulate the absolute value of foliar δ¹⁵N, while species-driven factors (e.g., timing and type of uptake) control the foliar δ¹⁵N value of one species relative to another in the same plot.