关于季节性冻土对兴隆林区的危害及防治措施

本文论述了在严寒地区预防和减轻基础冻害的方法及措施,并在实践中得到证实。     

钢筋混凝土框架—剪力墙结构非线性地震反应分析

The inelastic response of reinforced concrete plane frame-wall structures subjected to strong ground motions is studied from an analytical standpoint. In the analysis, the structure is idealized as the assemblage of prismatic members with two rigid zones     

Physicochemical properties of the thermal gel of water-washed meat in the presence of the more soluble fraction of porcine sarcoplasmic protein

We investigated the physicochemical properties of the thermal gel of water‐washed pork meat (WWM) in the presence of the soluble fraction of porcine sarcoplasmic protein (SP) obtained with ammonium sulfate at 75 percent saturation. Two precipitated fractions of SP were obtained at 0–50 percent and 50–75 percent saturation, named SP‐f1 and SP‐f2, respectively, and the soluble fraction obtained at 75 percent saturation, SP‐f3, was used. Sodium dodecyl sulfate‐polyacrylamide gel electrophoresis showed that SP‐f3 contained mainly glyceraldehyde‐3‐phosphate dehydrogenase (GAPDH), while SP‐f1 and SP‐f2 had other SPs such as phosphorylase b, enolase, actin and phosphoglycerate mutase. The gel strength of WWM was greater when SP‐f3 rather than one of various animal proteins such as bovine plasma (BP), egg white, or whey protein isolates (WPI), was added and SP‐f3 had a gel‐enhancing effect as good as that of polyphosphate (PP). The gel strength of WWM with added SP‐f3 increased significantly with NaCl at 0.15 mol/L or more, but not in the absence of NaCl (0 mol/L). The effect of SP‐f3 was evident at neutral pH and maximum gel strength was obtained at a pH above 6.0. Differential scanning calorimetric (DSC) analysis showed that an endothermic peak corresponding to myosin heads in WWM shifted to a lower temperature with the addition of SP‐f3, as in the case of PP, though there was no such shift in the presence of other animal proteins (BP, egg white and WPI), suggesting that SP‐f3 increases the gel strength of WWM through the dissociation of actomyosin similar to PP. Scanning electron microscopy (SEM) revealed wall‐like structures among the protein strands in the WWM gel matrix in the presence of SP‐f3. The results of DSC and SEM indicated that the formation of a gel network in meat products is reinforced with GAPDH in SP after the interaction between GAPDH and myofibrillar protein.     

浅谈孔隙率对沥青路面的影响

沥青混合料的孔隙率是一个重要的设计参数，其对于沥青路面的强度和使用性能有着重要的影响。在施工时，由于施工条件和设备的影响，不可能达到设计的孔隙率，于是一般要求用压实度作为施工时的一个控制指标，将沥青路面施工后的孔隙率控制在一个可接受的范围。在路面使用的初期，必然会有一段时间处于未完全压实工作状态，这种工作状态下，沥青路面能够提供的是未完全稳定的早期强度。在设计时，需要对比多个级配的混合料，确定合理的早期强度。     

Simultaneous measurement of soil water and soil hardness using a modified time domain reflectometry probe and a conventional cone penetrometer

Soil strength and water content are important indices for assessing soil resistance to root growth and soil compaction both of which affect other soil properties. Therefore, simultaneous measurement of soil penetration resistance (PR) and soil water content can aid agricultural land management. We measured PR with a conventional cone penetrometer, followed immediately by determining water content using a modified TDR probe inserted into the penetrometer hole. From the results of a field feasibility test, soil water content was measured satisfactorily and correlated well with data obtained by the gravimetric method, except for those data from near the surface owing to soil disturbance when the cone penetrometer was extracted after the PR measurements. Field results demonstrate that PR and soil water content have three‐dimensional variability, with a markedly different distribution pattern between cultivated and subsoil layers at the field scale. Overall, the variability in the PR and soil water data is similar to that reported in previous studies. We conclude that our method produces results helpful to field management of soil and water because it is based on a simple and easy technique for the simultaneous measurement of soil water content and PR.     

ZFS4800型液压支架的结构分析与强度计算

液压支架是煤炭工业中最主要的支护设备,为工人安全生产和设备的正常工作提供了保证.介绍了液压支架的工作原理,并使用Solid-edge软件对液压支架进行三维建模,完成了对液压支架的虚拟装配.通过对ZFS4800型液压支架的结构简化和分析,建立了液压支架的强度计算过程,结果表明其性能可靠.     

汽油机曲轴圆角和下沉量的研究

以某汽油机曲轴为载体,计算分析了曲轴的静态性能,并改变圆角半径和圆角下沉量的大小,分析对曲轴强度的影响,从而为圆角滚压工艺选取曲轴圆角参数奠定理论基础。     

Verification of mean volume backscattering strength obtained from acoustic Doppler current profiler by using sound scattering layer

ABSTRACT:   Acoustic Doppler current profilers (ADCPs) have recently been used to estimate the dynamic characteristics and biomass of sound scattering layers (SSLs) or swimming speed of fish schools and to analyze SSL spatial distribution or various behavior patterns. This paper shows that it is necessary to verify mean volume backscattering strength (MVBS, dB) values acquired from each beam for quantitative analysis of the spatial distribution or the biomass estimates of such specific targets as SSL or a fish school when using an ADCP. In this study, the SSL was selected to be a homogeneous density layer over a large area and two methods were used to verify the MVBS values from each beam of the ADCP. First, a mutual comparison among four beams was conducted after calculating MVBS from the measured echo intensity. Second, the MVBS values were verified using comparison between the calculated MVBS from the 153.6 kHz ADCP and MVBS from three frequencies of a well-calibrated scientific echosounder. Moreover, the dominant scatterers (euphausiids) were collected by a framed midwater trawl. From these samples, biological data were used to identify the different frequency characteristics between two systems, using a distorted-wave Born approximation (DWBA) theoretical backscattering model in order to assess the averaged target strength and target strength TS differences for the three frequencies.     

测试胶合板胶合强度的研究

通过对有关胶合强度测试的几个试验结果的分析,表明我国胶合板国家标准对胶合强度试验方法的规定具有先进性、合理性和可行性。