Characteristic site disturbance due to harvesting and extraction machinery traffic on sensitive forest sites with peat soils

The effects of wood harvesting and extraction machinery traffic on sensitive forest sites with peat soils were characterised with the objective of quantifying the threshold levels beyond which significant site impacts (compaction and rutting) would occur. The treatments involved running the machines in selected extraction racks (i.e., 3 m wide machine routes) while conducting normal wood thinning and extraction operations comprising one and two passes by the harvester and the forwarder with full payload, respectively. Soil disturbance thresholds were established by testing the level of significance of the difference in induced soil damage and compaction before and after machine traffic treatments. For volumetric soil water content lying between 10.0 and 14.9%, threshold cone penetration resistance levels for two 600/55–30.5 tyres were found to range from 594 to 640 kPa for deep-raised peat soil with initial strength lying between 524 and 581 kPa. In general, the proportion of the total rut depth data in each rack that exceeded the threshold level of 21.5 cm was about 5%. The threshold value corresponds to sinkage equivalent to 15% of the overall wheel diameter of the harvester, above which machine mobility would be hampered considerably. In addition, after harvester traffic the mean rut depth per unit rack length was 10.2×10⁻² cm/m, and it ranged from 0.7 to 24.7×10⁻² cm/m.     

Economic utility of 3D remote sensing data for estimation of site index in Nordic commercial forest inventories: a comparison of airborne laser scanning,digital aerial photogrammetry and conventional practices

ABSTRACT

Forest productivity is a crucial variable in forest planning, usually expressed as site index (SI). In Nordic commercial forest inventories, SI is commonly estimated by a combination of aerial image interpretation, field assessment and information obtained from previous inventories. Airborne laser scanning (ALS) and digital aerial photogrammetry (DAP) data can alternatively be used for SI estimation, however the economic utilities of the inventory methods have not been compared. We compared seven methods of SI estimation in a cost-plus-loss analysis, by which we added the expected economic losses due to sub-optimal treatment decisions to the inventory costs. The methods comprised direct and indirect estimation from combinations of ALS, DAP and stand register data, and manual interpretation from aerial imagery supported by field assessment and information from previous inventories (conventional practices). The choice of method had great impact on both the accuracy and the economic value of the produced estimates. Direct methods using bitemporal ALS and DAP data gave the best accuracy and the smallest total cost. DAP was a suitable and low-cost data source for SI estimation. Estimation from single-date ALS and DAP data and age obtained from the stand register provided practical alternatives when applied to even-aged stands.     

A new alpha-methylene gamma-lactone sesquiterpene from Hedyosmum arborescens

A new sesquiterpene lactone, 7alpha,10alpha-epoxy-1alpha(H),5alpha(H)-guaia-3,11(13)-dien-8alpha,12-olide, was isolated from the leaves of Hedyosmum arborescens. The structure of this unusual 7,10-epoxy-guaianolide was determined by spectroscopic methods, particularly one- and two-dimensional 1H and 13C NMR.     

Insektenzuchten auf künstlichen Medien

Ohne Zusammenfassung     

Antimicrobial flavonoids from the stem bark of Erythrina burttii

The chloroform extract of the stem bark of Erythrina burttii showed antifungal and antibacterial activities using the disk diffusion method. Flavonoids were identified as the active principles. Activities were observed against fungi and Gram(+) bacteria, but the Gram(-) bacteria Escherichia coli was resistant.     

Über Milbenauftreten in Pilzkulturen

Ohne Zusammenfassung     

Moisture content penetration in wood elements under varying boundary conditions

Knowledge of effects of moisture exposure on timber structures is important for serviceability and load bearing capacity of timber elements and systems. Varying climate affects the moisture content profiles in timber as the relative humidity changes in the ambient air. This paper presents methods for calculation of diffusion based moisture transport and corresponding results on how timber responds to varying moisture with regard to moisture penetration and distribution. The calculations are based on measured outdoor relative humidity and temperature at different climatic locations in Sweden. No remarkably large deviations between the different climatic locations were found in general, which is positive in a design code perspective.     

Impacts of seasonal air and soil temperatures on photosynthesis in Scots pine trees

Seasonal courses of light-saturated rate of net photosynthesis (A360) and stomatal conductance (gs) were examined in detached 1-year-old needles of Scots pine (Pinus sylvestris L.) from early April to mid-November. To evaluate the effects of soil frost and low soil temperatures on gas exchange, the extent and duration of soil frost, as well as the onset of soil warming, were manipulated in the field. During spring, early summer and autumn, the patterns of A360 and gs in needles from the control and warm-soil plots were generally strongly related to daily mean air temperatures and the frequency of severe frost. The warm-soil treatment had little effect on gas exchange, although mean soil temperature in the warm-soil plot was 3.8 degrees C higher than in the control plot during spring and summer, indicating that A360 and gs in needles from control trees were not limited by low soil temperature alone. In contrast, prolonged exposure to soil temperatures slightly above 0 degrees C severely restricted recovery of A360 and especially gs in needles from the cold-soil treatment during spring and early summer; however, full recovery of both A360 and gs occurred in late summer. We conclude that inhibition of A360 by low soil temperatures is related to both stomatal closure and effects on the biochemistry of photosynthesis, the relative importance of which appeared to vary during spring and early summer. During the autumn, soil temperatures as low as 8 degrees C did not affect either A360 or gs.     

Determinants of biomass production in hybrid willows and prediction of field performance from pot studies

Pot experiments are often performed to assess plant physiological traits and relationships among growth traits under controlled environments. However, the reliability of pot studies for predicting the growth and performance of trees in the field has rarely been rigorously assessed. We evaluated the suitability of pot experiments for predicting field performance, measured as shoot biomass production, by investigating determinants of growth in hybrid willows (Salix spp.) grown under various environmental conditions in the field, and by comparing the data with the results from a corresponding pot study. Biomass production in six hybrid willow clones, bred for use as bio-fuels, was assessed in three field trials located in central and southeastern Sweden throughout the first 3-year cutting cycle. The determinants of biomass productivity, measured as biomass allocation and nitrogen (N) economy, were identified in one of the field trials. Key traits for shoot biomass production in the field were total leaf area and total amount of N; plant N losses by shed leaves were only partly controlled by leaf-litter N concentration. These key traits were also obtained from the pot study and related to shoot biomass production and abscission-leaf N loss in the field. Total leaf area and total N pool of plants grown in pot experiments were good predictors of long-term biomass production in the field, whereas shoot biomass production, specific leaf area and tissue N concentration of pot-grown plants were less suitable as predictors of field performance. Relationships between the key traits and shoot biomass production were clone-specific, indicating the need for analysis of growth traits at the clone level if field performance of trees is to be evaluated based on data from pot studies. Nutrient loss components are important for tree performance in the long term and evaluations of nutrient loss characteristics at the individual-tree level should focus on nutrient pools lost rather than on nutrient concentrations in abscised plant parts.