Measured and estimated water use and crop coefficients of grapevines trained to overhead trellis systems in California’s San Joaquin Valley

The use of overhead trellis systems for the production of dry-on-vine (DOV) raisins and table grapes in California is expanding. Studies were conducted from 2006 to 2009 using Thompson Seedless grapevines grown in a weighing lysimeter trained to an overhead arbor trellis and farmed as DOV raisins for the first two years and for use as table grapes thereafter. Maximum canopy coverage for the two lysimeter vines across years was in excess of 80 %. Seasonal (15 March–31 October) evapotranspiration for the lysimeter vines (ET_Lys) was 952 mm in 2007 (farmed as DOV raisins) and 943 and 952 mm (when farmed as table grapes). The maximum crop coefficient (K _cLys) across all 4 years ranged from 1.3 to 1.4. These maximum values were similar to those estimated using the relationship where K _c is a function of the amount of shaded area measured beneath the canopy at solar noon (K _c = 0.017 × percent shaded area). Covering the lysimeter’s soil surface with plastic (and then removing it) numerous times during the 2009 growing season (1 June–14 September) reduced ET_Lys from an average of 6.4 to 5.6 mm day^?1 and the K _c from 1.07 to 0.93. A seasonal basal K _c (K _cb) was calculated for grapevines using an overhead trellis system with a 13 % reduction in the K _cLys across the growing season.     

Crop response of drought-tolerant and conventional maize hybrids in a semiarid environment

In the High Plains, corn (Zea mays L.) is an important commodity for livestock feed. However, limited water resources and drought conditions continue to hinder corn production. Drought-tolerant (DT) corn hybrids could help maintain high yields under water-limited conditions, though consistent response of such hybrids is unverified. In this two-year study, the effects of three irrigation treatments were investigated for a DT and conventional maize hybrid, Pioneer AQUAMax P0876HR and Pioneer 33Y75, respectively. In 2013, the drier of the 2 years, irrigation amounts and crop water use (ET_c) were greater for the conventional hybrid, but grain water use efficiency (WUE) and harvest index were significantly greater for the DT hybrid. In 2014, grain yields and WUE were not significantly different between hybrids. However, irrigation amounts, ET_c and biomass yields were greater for the conventional hybrid. Results from both years indicate that the DT hybrid required less water to maximize grain yield as compared to the conventional hybrid. Producing relatively high yields with reduced amounts of water may provide a means for producers to continue corn production in a semiarid environment with declining water supplies.     

Modeling soil water dynamics in a drip-irrigated intercropping field under plastic mulch

Intercropping, drip irrigation, and the use of plastic mulch are important management practices, which can, when utilized simultaneously, increase crop production and save irrigation water. Investigating soil water dynamics in the root zone of the intercropping field under such conditions is essential in order to understand the combined effects of these practices and to promote their wider use. However, not much work has been done to investigate soil water dynamics in the root zone of drip-irrigated, strip intercropping fields under plastic mulch. Three field experiments with different irrigation treatments (high T1, moderate T2, and low T3) were conducted to evaluate soil water contents (SWC) at different locations, for different irrigation treatments, and with respect to dripper lines and plants (corn and tomatoes). Experimental data were then used to calibrate the HYDRUS (2D/3D) model. Comparison between experimental data and model simulations showed that HYDRUS (2D/3D) described different irrigation events and SWC in the root zone well, with average relative errors of 10.8, 9.5, and 11.6 % for irrigation treatments T1, T2, and T3, respectively, and with corresponding root mean square errors of 0.043, 0.035, and 0.040 cm³ cm^?3, respectively. The results showed that the SWC in the shallow root zone (0–40 cm) was lower under non-mulched locations than under mulched locations, irrespective of the irrigation treatment, while no significant differences in the SWC were observed in the deeper root zone (40–100 cm). The SWC in the shallow root zone was significantly higher for the high irrigation treatment (T1) than for the low irrigation treatment, while, again, no differences were observed in the deeper root zone. Simulations of two-dimensional SWC distributions revealed that the low irrigation treatment (T3) produced serious severe water stress (with SWCs near the wilting point) in the 30–40 cm part of the root zone, and that using separate drip emitter lines for each crop is well suited for producing the optimal soil water distribution pattern in the root zone of the intercropping field. The results of this study can be very useful in designing an optimal irrigation plan for intercropped fields.     

Sensitivity analysis of optimal operation of irrigation supply systems with water quality considerations

A model for optimal operation of water supply/irrigation systems of various water quality sources, with treatment plants, multiple water quality conservative factors, and dilution junctions is presented. The objective function includes water cost at the sources, water conveyance costs which account for the hydraulics of the network indirectly, water treatment cost, and yield reduction costs of irrigated crops due to irrigation with poor quality water. The model can be used for systems with supply by canals as well as pipes, which serve both drinking water demands of urban/rural consumers and field irrigation requirements. The general nonlinear optimization problem has been simplified by decomposing it to a problem with linear constraints and nonlinear objective function. This problem is solved using the projected gradient method. The method is demonstrated for a regional water supply system in southern Israel that contains 39 pipes, 37 nodes, 11 sources, 10 agricultural consumers, and 4 domestic consumers. The optimal operation solution is described by discharge and salinity values for all pipes of the network. Sensitivity of the optimal solution to changes in the parameters is examined. The solution was found to be sensitive to the upper limit on drinking water quality, with total cost being reduced by 5% as the upper limit increases from 260 to 600 mg Cl l^–1. The effect of income from unit crop yield is more pronounced. An increase of income by a factor of 20 results in an increase of the total cost by a factor of 3, thus encouraging more use of fresh water as long as the marginal cost of water supply is smaller than the marginal decrease in yield loss. The effect of conveyance cost becomes more pronounced as its cost increases. An increase by a factor of 100 results in an increase of the total cost by about 14%. The network studied has a long pipe that connects two distinct parts of the network and permits the supply of fresh water from one part to the other. Increasing the maximum permitted discharge in this pipe from 0 to 200 m³ h^–1 reduces the total cost by 11%. Increasing the maximum discharge at one of the sources from 90 to 300 m³ h^–1 reduces the total cost by about 8%.     

“WaterMan”: an on-farm water management game with heuristic capabilities

A modern computer-based simulation tool (WaterMan) in the form of a game for on-farm water management was developed for application in training events for farmers, students, and irrigators. The WaterMan game utilizes an interactive framework, thereby allowing the user to develop scenarios and test alternatives in a convenient, risk-free environment. It includes a comprehensive soil water and salt balance calculation algorithm. It also employs heuristic capabilities for modeling all of the important aspects of on-farm water management, and to provide quantitative performance evaluations and practical water management advice to the trainees. Random events (both favorable and unfavorable) and different strategic decisions are included in the game for more realism and to provide an appropriate level of challenge according to player performance. Thus, the ability to anticipate the player skill level, and to reply with random events appropriate to the anticipated level, is provided by the heuristic capabilities used in the software. These heuristic features were developed based on a combination of two artificial intelligence approaches: (1) a pattern recognition approach and (2) reinforcement learning based on a Markov decision processes approach, specifically the Q-learning method. These two approaches were combined in a new way to account for the difference in the effect of actions taken by the player and action taken by the system in the game world. The reward function for the Q-learning method was modified to reflect the suggested classification of the WaterMan game as what is referred to as a partially competitive and partially cooperative game.     

Adsorption kinetics of 17α-ethinyl estradiol and bisphenol A on carbon nanomaterials. II. Concentration-dependence

Purpose  

Carbon nanomaterials (CNMs) have attracted a great deal of research interest for their potential environmental applications because of their unique properties. Adsorption of organic chemicals on CNMs was reported to be important in controlling their environmental risks. However, the kinetics of the adsorption is hardly investigated in literature. The objective of this work was, therefore, to quantitatively describe the sorption kinetics of 17 α-ethinyl estradiol (EE2) and bisphenol A (BPA) on CNMs as compared to activated carbon (AC).     

Biochemical properties,molecular characterizations,functions, and application perspectives of phytases

As a kind of enzyme widely existing in eukaryotic species, especially in grains and oil seeds, phytases play an important role in the degradation of some phosphates containing organic molecules. So far, phytases derived from various species have been successfully used as animal feed additives. It has also been experimentally verified that phytases have a potential use in generating crop germplasm with high phosphorus use efficiency, based on their biochemical role in releasing Pi from the phytate and its derivatives. In this paper, the biochemical properties, molecular characterizations, functions and the potential application perspective of phytases are reviewed and commented on, aiming at the further exploration of the biochemical and molecular characterizations, and promotion of the application of phytases, a kind of important enzyme possessing potential use in animal feeding and creation of high P use crop cultivars, in the future.     

Identification of molecular markers linked to the genes for purple grain color in wheat (<Emphasis Type="Italic">Triticum aestivum</Emphasis>)

Pericarp color in wheat is an important trait related to nutrients and health benefits. Identification of molecular markers closely linked to the grain color genes will help utilize pericarp trait in wheat breeding. Genetic studies involving F₁, F₂, and F₃ populations from the cross Jizi 439 (purple grain)/Gao8901 (white grain) showed that the purple grain color was controlled by two genes. By using the bulked segregant analysis (BSA) approach, two DNA pools were established from the dark purple-grain and white-grain plants respectively. Among the 230 pairs of microsatellite primers used in this study, two markers showed polymorphism in DNA pools, parents, F₁ and F₂ populations. Linkage analysis indicated that the two markers Xgwm47 and Xgwm155 were linked with two purple pigment genes. One of the purple pigment genes is located on chromosome 2AS and is 34.7cM away from the marker Xgwm47, whereas another gene is mapped on 3AL with 14.7cM away from marker Xgwm155.