Channel Characteristics of Low Voltage Power Line

In order to make good use of power line carrier to communicate, it is necessary to analyze the time-variable, impedance,attenuation and noise characteristics of low voltage power line. The waves of every characteristic have been experimented. At the same time, aiming at these characteristics, some available measures are given in order to conquer the disadvantage factors. The experimental results show that some suitable carrier communication modes must be adopted to realize ideally the carrier communication on low voltage power line.     

An optimal equivalent subchannel algorithm for low voltage power line communication system

According to the low voltage power line channel features,combined with adaptive bit loading and power allocation algorithm,an optimal equivalent subchannel algorithm is proposed.Under the condition of fixed amount of transmitted bits and the minimum transmitted power model,impact of optimal equivalent subchannel on the system performance is studied.The optimization algorithm sorts subchannels with similar transmission features into groups,thus the signaling load can be reduced,and the spectrum can be better used.The simulation results show that system can get lower bit error rate(BER) by adopting optimal equivalent subchannel algorithm.     

Bit Allocation Algorithm OFDM Systems Based for Low Voltage Network Transmitted Efficiency

Selfadaptation OFDM is suitable for the low voltage network.To satisfy the request of high speed communication in low voltage network,this paper studies a bit allocation algorithm for low voltage network OFDM systems based transmitted efficiency.And compared with the fix modulate OFDM and fix power OFDM,this algorithm can allocate the power and modulate flexibly and increase the speed.It is very appropriate for the low voltage network application.     

Model and Numerical Analysis of Radiation Field Created by Lightning Overvoltage Wave on Transmission Lines

The radiation field created by the transmission line stroked by lightning far from the lightning channel has been analyzed by the FDTD method.The authors we establish the calculation model and FDTD calculation method of transmission line,and discusses the import of lightning excitation source.The simulation of lightning stroked on a single transmission line in free space or stroked on three-phase high voltage transmission lines in actual environments has been done,and gives the distribution of transient radiation field around the transmission lines when lightning overvoltage wave transmits along the transmission line.The simulation result shows that: the effect of the transient radiation field caused by lightning over voltage wave done with environment is obvious,and the high frequency component of transient radiation field may disturb or do harm to the electronic facility or communication facility around the transmission lines.     

Design of the distributed wireless monitoring system

For the limitations of the traditional monitoring systems under the circumstances of dispersed monitoring points, wide distribution range and the harsh environment, a distributed wireless monitoring system based on radio frequency technique is designed. The system adopts the ultra low power consumption MCU MSP430 as the main control chip and extends several processing module in the periphery. In addition, the multi channel transceiver nRF905 is used for wireless data transmission. The software and hardware design scheme of the proposed system and the communication protocol for distributed data transmission are discussed. Frequency hopping mechanisms are employed to increase the reliability of data transmission. The results show that the proposed system has the characteristics such as flexible use and excellent mobility, while can monitor multipoint data in special environment in real time.     

Calculation of lumped parameter of two-port network forvolume conduction energy transfer

Skin electrode unit is a channel through which energy can be transferred to the implanted device by volume conduction. The unit can be equivalent to lumped circuit, but so far there are no appropriate calculation methods of these circuit parameters, so variable load method based on field-circuit coupled is proposed. A skin electrode unit field circuit coupled model is established to obtain the relationship of the network parameters between voltage and current at electrode port, and the amplitude and phase of the power signal is extracted by the use of all phase FFT spectrum analysis. On this basis, equivalent circuit impedance parameters of the skin electrode unit under various conditions are obtained by the application of variable load method and the validity of the method is verified. As a result, the equivalent circuit impedance parameters obtained in this way can be used for the circuit analysis and optimization of the volume conduction energy transfer system.     

Comparative study of aircraft three-phase power factor corrections

This paper summarizes the requirements of standards for aircraft power supply firstly,and then points out that the input current harmonic and output DC voltage ripple should be considered seriously when designing three-phase power factor correction (PFC)for aircraft under variable line frequency and unbalanced line supply. Based on reviewing the topologies for aircraft three-phase PFC,three typical topologies,i.e. three-phase pulse width modulation (PWM)rectifier,traditional shunt active power filter (APF)and generalized APF,are picked up. A unified single-phase equivalent model is developed for comparing the harmonic suppression performance of the three active PFC schemes. And the switching stress is also calculated for evaluating their efficiency and power density. Three 5 kW PFC are designed by employing each of the three selected schemes. Simulation is carried out to verify the correctness of the theoretical analysis. The theory and simulation results indicate that the generalized APF topology shows the most technical merit for aircraft three-phase PFC. Future research works on generalized APF are also pointed out,which are solving the uncontrollability of its DC output voltage and optimal designing the filter inductors.     

烟草细胞质雄性不育系及其保持系的花蕾差异蛋白质分析

为探讨烟草雄性不育的分子遗传机理,对烟草细胞质雄性不育系和保持系进行差异蛋白质组学研究。采用固相pH梯度SDS-PAGE双向电泳,对烟草细胞质雄性不育系MSK326及其保持系K326雄蕊原基分化期、四分体时期及单核时期花蕾蛋白质进行分离,经考马斯亮蓝染色,获得了分辨率和重复性较好的双向电泳图谱。使用PDQuest软件分析蛋白质图谱,利用基质辅助激光解吸电离飞行时间串联质谱分析,然后用Mascot软件对NCBInr数据库搜索。在分子量14.4~97.6 kD、等电点4~7线性范围内,检测到约365个蛋白点,其中7个蛋白质点在保持系中出现, 在不育系中缺失,分别被鉴定为核酮糖-1,5-二磷酸羧化酶/加氧酶、多酚氧化酶、Patatin homolog蛋白、PSI 9 kD蛋白4类蛋白,推测不育系MSK326雄性不育性可能与营养代谢紊乱、间接抑制雄性器官发育、养分供给不足、免疫能力低和能量转移受到抑制等有关。     

Multiple Turbo Codes for Satellite Communications

Satellite communication channel has the characteristic of power limited, band abundance, and powerful error correcting ability FEC scheme is needed. For its near Shannon limit error correcting capability, Turbo codes may be suitable for satellite communication systems. The multiple Turbo codes can utilize channel capacity sufficiency and overcome the disadvantages of power limited for satellite communication systems. Force on the needed for satellite communication systems, multiple Turbo codes is adopted and server decoding schemes were proposed with simulation. Simulation results show that, the schemes proposed can get near channel capacity error correcting performance with short code block.     

Parameter design and simulation for animproved direct current side active power filter

Considering the characteristics of the dc side series active power filter (APF) that the output voltage cannot be adjusted and the control circuit is complex , an improved single phase dc series APF topology is proposed. The improvement of the new circuit topology and fundamental working principle are analyzed. Following the circuit power factor pre regulator principle, the designing method for the main circuit parameters is given. The voltage ring and the current ring are designed by using the zero pole method. The main circuit power switch is controlled with the same frequencies, while the control circuit was simplified further. Compared with the paralleled APF, the main circuit of topology structure is simplified and the number of the active switches is reduced, which show low input current harmonics, high power factor, large voltage output adjustment range and low cost. The simulation results prove that the proposed topology is correct and reliable.     

Application of Serial Ports Simulation in a Non-communication Fault Detection Device of Distribution Networks

This paper summarizes two kinds of fault detection techniques for distribution automation, that is with and without communication in fault detection, and then analyzes their merits and shortcomings. Moreover, according to the development tendency of distribution automation techniques, this paper presents an approach, through which the noncommunication FTU devices can detect transient fault voltage of distribution systems effectually. To detect transient fault voltage without standby batteries, the PIC Single Chip microcomputer with low power consumption and DSP chip with powerful data processing capabilities are adopted to form a dual CPU system. To realize the communication between the two CPUs, the general I/O port,s of the DSP chip are firstly used to simulate the UART communication of the serial ports and communicate with the PIC Single Chip microcomputer. The novel FTU devices based on this approach are tested in static and dynamic simulation experiments, the results are satisfied.     

Voltage and Reactive Power Optimization of Main Electric Power Network in Chongqing

Based on the reactive surplus of Chongqing 220 kV main electric power network under low water and low load, and on state of higher system voltage, a thorough research is done on voltage and reactive power of the system power network by means of calculation,analysis and experiments. A main network calculating equivalence model of power network in Chongqing is constructed. And reactive power optimizing calculation is figured out on the Chongqing power network on condition that the loss minimum of the active power network is object function. Several optimizing compensatory schemes are put forward. Based on the calculation result and the analysis of all schemes, the most reasonable and feasible optimizing scheme could be achieved. Meanwhile, the feasibility that the system voltage could be adjusted when generator operating under excitation was demonstrated. According to the experience of under-excitation operation of the same type units , it decreases the system voltage, improves Chongqing power network running performance, and strengthens the coordination and stabilization of system.     

A Novel Adjustable Peterson Coil

The paper presents a novel continuously adjustable Peterson coil. If it is used in the system of neutral point grounding through Peterson coil, not only the high price can be reduced and the complicated problems can be solved of which the high voltage inductance controlling systems, but also advantages of the system of neutral point grounding though Peterson coil can be shown. It is introduces that how adopts low voltage thyristors for continuing adjusting inductance of the Peterson coil of which the voltage level ranges from 6 kV to 66 kV. This paper discusses the formula of calculating the inductance variable ranges and the harmonic currents which presents stable harmonic current under the phase controlled mode also. The theory of the designing coil is verified by the Saber simulation and practicality experiment.     

A preventive control model for static voltage stability considering the power constraints of weak branches

The voltage instability of power system often occurs when the active power on one or more weak branches exceeds its transfer capability. A preventive control model for static voltage stability is proposed using the active power transfer capability of weak branches as static voltage stability constraints. A local line based voltage stability index is used to determine the critical contingencies, weak branches and transfer capability of each weak branch. A static security analysis method, which is based on DC power flow equations, is used to establish the non linear active power flow expressions on weak branches following each critical contingency. The active power constraints on weak branches can be obtained from the active power flow expressions and transfer capabilities of weak branches. A quadratic optimal model for preventive control including the proposed active power constraints on weak branches is presented. The simulation results for IEEEE14 bus system and IEEE118 bus system demonstrate the correctness and effectiveness of the proposed preventive control model.     

应用STATCOM的DFIG风力发电机低电压穿越能力分析

针对DFIG（double fed induction generator）风电机组低电压穿越能力（LVRT,low voltage ride through）问题,笔者基于STATCOM研究了一种电压外环与电流内环相结合的双闭环反馈控制策略,并仿真验证了所提出方法的有效性。将STATCOM分别安装风电机组机端、并网点高压侧和低压侧,且设置不同电压跌落深度,比较其补偿效果。实验结果表明,安装在风电机组机端时补偿效果最好。在电网电压跌落时,STATCOM能快速为电网输入无功,抬高风力机的机端电压,从而提高风电场的LVRT能力,从STATCOM输出无功大小和风电场机端电压被抬升的比例两方面分析,对于不同深度的电压跌落,STATCOM补偿效果都较为显著。     

大功率P沟道VDMOS器件设计与工艺仿真

作为现代电力电子核心器件之一的P沟道VDMOS （vertical double-diffuse,MOS）器件,一直以来由于应用领域狭窄而并未得到足够的研究。以P沟道VDMOS器件为研究对象,为一款击穿电压超过-200 V的P沟道VDMOS设计了有源区的元胞结构及复合耐压终端结构,并开发了一套完整的P沟道VDMOS专用非自对准工艺流程。最后通过仿真得到器件的击穿电压超过-200 V,阈值电压为-2.78 V,完全满足了设计要求,也为下一步流片提供了有益的参考。     

A power distributed computing system model based on services-oriented architecture

Process communication based power distributed computing model satisfies the demand on real time monitoring and analysis for the economical operation of power grid based on power distributed computation methods, but there are some problems on complexity in common basic functions development and lack of system extendibility. An extendable services-oriented power distributed computation system model is designed and implemented. Software design patterns are applied to design low coupling and extendable system framework. Windows Communication Foundation (WCF) technology is used to implement the services-oriented distributed data communication functions. Windows Workflow Foundation (WWF) technology is used to design the business logic of power distributed computation visually. Data integration functions are implemented by combining the ADO.NET technology. The services-oriented system architecture enhances the integration ability and extendibility. The use of WCF and WWF technology reduces the complexity of the system development.     

Analysis of Unified Power Flow Controller in Damping Low Frequency Oscillation of Power System

With the development and complication of power system, the problem of low frequency oscillation in electric network becomes obvious. Unified Power Flow Controller is one of the most powerful facilities in Flexible AC Transmission Systems, which can improve the transient stability and damp the low oscillation in power system with suitable control. Considering the characteristics of inverter's output voltage magnitude, adjustment of phase and process of charge and discharge of dc capacitance, the dynamic model of UPFC is proposed by a series of nonlinear differential coefficient equations. Based on UPFC's dynamic model, the linear optimal controller of UPFC with state feedback is proposed. In this way, the low frequency oscillation is damped effectively. A simulation is processed basing the theory.     

Improved CMI code in passive induction setting system 〖JP〗

Aiming at the low energy transmission efficiency of the passive induction setting system with the existing codes, an improved CMI code is proposed as baseband code by changing the equivalent average time of high level during a code cycle under 2ASK modulation. The properties are analyzed, such as energy transmission efficiency, power spectrum and the error probability in incoherent demodulation in AWGN channel. The code is successfully applied to passive induction setting system, and the decoding method and measured voltage waveform are given. With the code, the energy transfer efficiency is improved by 60% than that of CMI code. It is not only beneficial to energy transmission, but also has the merit of CMI code that the bit timing information is extracted easily, which is fully utilized in incoherent demodulation to solve the sampling moment error accumulation problem resulted from the instability of internal oscillator.