A Subchannel Allocation Policy of Multicarrier CDMA

To attain high rate data and high quality of service in wireless communication, a subchannel allocation policy combined with subcarriers and power allocation is proposed. In the proposed system, instead of identical power over the subcarriers in parallel, each user's DS waveform is transmitted over the subchannels that have large fading amplitude among all the subchannels. The powers of the subcarriers with small fading amplitude are allocated to the subcarriers with large ones. It can effectively suppress multiple-access interference while obtaining diversity gains. The allocation policy based on fading amplitudes has the advantages of low computation and good convergence compared with the policy proposed in other papers. Thus, it is suitable for engineering.     

Bit Allocation Algorithm OFDM Systems Based for Low Voltage Network Transmitted Efficiency

Selfadaptation OFDM is suitable for the low voltage network.To satisfy the request of high speed communication in low voltage network,this paper studies a bit allocation algorithm for low voltage network OFDM systems based transmitted efficiency.And compared with the fix modulate OFDM and fix power OFDM,this algorithm can allocate the power and modulate flexibly and increase the speed.It is very appropriate for the low voltage network application.     

Distributed Power Flow Method Based on Ward Equivalent

With interconnecting and developing of power system, the problem of power flow computation on dispersed data resource need to be solved. A new distributed computation method of power flow based on Ward equivalent is presented. According to master-slaver splitting principle, multi-area interconnected power system is divided into master-slaver areas. Boundary buses in different areas are defined as different bus-types. Neighborhood areas are equivalent by Ward equivalent principle, and the equivalent injection power and equivalent impedance are worked out. Power flows from master area to slaver areas are solved by Newton method, and the equivalent injection power and equivalent impedance on the boundary are modified by their solutions. The process above repeats until to convergence. The proposed distributed power flow method takes full advantage of the information of power, voltage, network configuration in neighborhood areas, so it is better on convergence and quality of solution. The proposed algorithm is testified by IEEE 14-bus system and a practical 181-bus system.     

EQUIVALENT-UNIT METHOD OF SHORT-TERM RELIABILITY EVALUATION FOR INTERCONNECTED POWER SYSTEMS

This paper presents the concept of equivalent-unit and the solution method of state probabilities for short-term reliability evaluation for generation systems. The ideas and methods are applied to evaluate short-term reliability of intercommected power systems,and the models of equivalent assistance,which can be conveniently combined with subsystem models,are propesed. The models and algorithm proposed not only solve the difficult problem of "state explosion" , but also improve the calculating accuracy. A numerical example is given to show that the models and algorithm are feasible and effective.     

Improved CMI code in passive induction setting system 〖JP〗

Aiming at the low energy transmission efficiency of the passive induction setting system with the existing codes, an improved CMI code is proposed as baseband code by changing the equivalent average time of high level during a code cycle under 2ASK modulation. The properties are analyzed, such as energy transmission efficiency, power spectrum and the error probability in incoherent demodulation in AWGN channel. The code is successfully applied to passive induction setting system, and the decoding method and measured voltage waveform are given. With the code, the energy transfer efficiency is improved by 60% than that of CMI code. It is not only beneficial to energy transmission, but also has the merit of CMI code that the bit timing information is extracted easily, which is fully utilized in incoherent demodulation to solve the sampling moment error accumulation problem resulted from the instability of internal oscillator.     

OPTIMAL REACTIVE POWER FLOW BY SENSITIVITY METHOD

A new approach based on sensitivity method for the optimal power flow is presented in the paper. This method has the following advantages: it is suitable to solve a 200-node power system on the microcomputer; the convergence is easy to reach and the computation speed is quick; it is possible to reduce 8-14% power loss and to get maximum economic benefit by using this method; in power system dispatch center it can be used as an on-line voltage and reactive power control program to keep good voltage level. The proposed method has been proved successful by IEEE 118-node test system and the several real power systems such as 49-node, 61-node, 99-node and 200-node systems.     

Research on the improvement of the convergencespeed for CDMA system power control

Optimal power control with game-theory has been a hot research topic in code division multiple access (CDMA) system. However, the convergence speed of the power control algorithm based on traditional static game-theory is not fast enough and the power fluctuation is large during the iterative process. In order to solve this problem, dynamic game-theory is introduced into CDMA system power control algorithm. The simulation results show that the proposed algorithm, compared with the distributed power control algorithm based on the traditional static game theory, can improve the convergence speed obviously with the same power spending.     

Hybrid Intelligent Method for Dynamic Reactive Power Optimization

In dynamic reactive power optimization problem(DRPO), action number constraints of discrete variables should be considered.By integrating immune genetic algorithm(IGA) and nonlinear interior point method(NIPM), a hybrid method for DRPO is proposed.First,the original DRPO problem is converted to a continuous optimization problem by relaxing the discrete variables,and the solution is obtained by NIPM.Then,according to the feature of control variables,the original DRPO problem is decomposed into a continuous optimization sub-problem and a discrete optimization sub-problem.The discrete optimization sub-problem is solved by IGA,and the continuous one is solved by NIPM.By solving the two sub-problems alternately,the optimal solution of the DRPO can be obtained.The proposed hybrid method combines advantages of IGA and NIPM,and finds the approximate optimal solution of DRPO.Numerical simulations on the IEEE 14 bus system illustrate that the proposed hybrid method is effective.     

电网可靠性评估的网络静态等值模型分析

为缓解大电网可靠性评估的计算复杂性，采取等值参数联合概率密度分布建模的方式开展了外网静态等值研究。在常规确定性静态Ward等值技术基础上，考虑外部区域发电机和线路随机故障，通过计算各种随机故障状态下的外网等值参数，即外网等值注入功率和外网等值串联支路阻抗，基于概率密度估计技术建立了等值参数的联合概率密度分布。外网静态概率等值模型克服了常规确定性静态Ward等值技术的不足，充分计入外网等值参数的随机性，减少了电网可靠性评估计算时间的同时提高了计算精度。对两区域RBTS系统和RTS79系统研究验证了其有效性和准确性。     

Reliability evaluation algorithm for complex electrical distribution networks using the storage structure of adjacency multilist

A section algorithm of reliability evaluation for complex medium voltage Electrical Distribution Networks (EDNs) using adjacency multilist (AM) is proposed. The constructing method for AM is introduced. The AM can be used to store the structure data of EDNs and to solve the problem of space & time complexity. A new power flow algorithm of backward / forward sweep is proposed and a fast algorithm of forming sections in distribution network is put forward. The proposed algorithm makes a perfect combination of the power flow algorithm and the section algorithm of reliability evaluation, which makes efforts to decrease the work of programming and saves the computing time. Applying the proposed algorithm in RBTS-BUS6 system and actual EDNs, the reliability assessment results show that the algorithm has an advantage of saving time and possesses efficiency in engineering practicality.     

Reliability Evaluation for Bulk Power System Including Dependent Outage of Transmission Line

In order to calculate and analyze the effect of two transmission lines in parallel on the reliability evaluation of bulk power system, a model including independent outage, common mode outage and dependent outage of these lines is deduced and a new algorithm corresponding to the model is presented. Two transmission lines in parallel including common mode outages and dependent outages can be really simulated as a multi-state component. While reliability indices are calculated, the probability and frequency of independent outage, common mode outage and dependent outage of a system failure state can be calculated at the same time, and computation complexity is reduced. The proposed model and algorithm are applied to the RBTS system, IEEE One Area RTS96 system and a real power system for reliability computation and analysis. Results show that the new algorithm is credible and validity.     

AN A. C. LOAD FLOW ANALYSIS OF THE RELIABILITY EVALVATION OF COMPOSITE GENERATION AND TRANSMISSION SYSTEMS

An A. C. load flow analysis of the reliability evaluation of composite generation and transmission systems is presented on the basis of a fast outage simulation algorithm and an optimal model of active and reactive power adjustment after outage contingencies. The information of the first -level outage events is utilized for simulating higher -level outage events in the fast outage simulation algorithm ; the optimal model is satisfactory in speed and accuracy with the application of concentric relaxation and linear increment constraint on the comprehensive adjustment of active and reactive power. As an example. the IEEE Reliability Test System is tested and the results show that the method is accurate and well-matched in speed with the method studied by R. Bllinton, et al.     

从输电阻塞角度建立的风电场容量可信度模型

风电并网时既要考虑系统的可靠性又要考虑输电阻塞。目前风电场容量可信度仅从可靠性单一角度提出。为此从输电阻塞角度提出了风电场容量可信度的定义;通过Monte Carlo法建立计及元件故障(发电机、线路和变压器)的风电场容量可信度模型,并提出该模型的二分法求解算法;同时还提出了风电阻塞指标以描述风电场并入电力系统对缓解系统输电阻塞的贡献。通过对修改的IEEE-RTS进行算例分析,验证了方法的正确性和实用性。结果表明：系统阻塞状况的缓解程度与并入风电场的位置有关,风电场容量可信度和风电阻塞指标相结合可以评价风电场并网对系统阻塞状况改善的有效性和经济性。     

The Multi-objective Fuzzy Optimal Power Flow Model and its Neural Network Algorithm

This paper has presented a multi-objective fuzzy optimal power flow medel.Inthe model , the multiple objectives, such as the minimum generation cost and the minimum powerloss, have been considered simultaneously, A new algorithm based on neural network models is aisopresented,in which the neural networks are employed to express, the membership function of fuzzysets and solve the optimization problems. The validity of model and algorithm is verified with numerical examples.     

An Improved Genetic Algorithm for Optimum Design of Power Transformers

In order to enhance the ability of global searching for genetic algorithm in power transformers optimization design, some interrelated key technique problems such as encoding method, genetic operators, restrict condition, fitness function for the traditional genetic algorithm are further reformed. An Improved Genetic Algorithm (IGA) is developed. The optimal results of a representative mathematical example show that IGA has high efficiency of global searching. At the same time, a multi-objective algorithm based on IGA is studied in this paper. IGA is applied to the single and multi-objective optimum design of S9 power transformers for the first time. All the achievements in the paper are verified a practical S9-1000/10 kV power transformer. All the optimization results are satisfactory and show that IGA has powerful ability of global searching, excellent solution precision and has a bright application prospect in the fields of power transformers design.     

传递功率对行星齿轮传动系分岔特性的影响规律

针对行星齿轮减速器工作过程中传递功率的频繁变化容易导致其运动状态发生突变的问题,探讨行星齿轮传动系统随传递功率的分岔特性。基于2K-H型行星齿轮传动系统纯扭转非线性动力学模型,采用CPNF(continuous Poincaré-Newton-Floquet)方法研究了传递功率对行星齿轮传动系统周期运动稳定性的局部精细分岔规律,运用直接数值积分的方法绘制了系统随功率的全局分岔图,并对两种仿真结果进行了对比。结果发现,在某些参数组合下,行星齿轮传动系统会共存几个稳定或不稳定的周期轨道;当功率在196~220 kW范围内,随着功率值的逐渐增大,行星齿轮传动系统的各种形态的周期轨道均是通过倍周期倒分岔的途径在相应功率分岔点处发生稳定性突变的;在轻载工况下(传递小功率),行星齿轮非线性系统容易呈现混沌运动状态。     

A New Algorithm for Open Conductor Faults in Power Systems with Variable Structures

A new method to calculate electric values of unsymmetrical open conductorfaults in power systems with variable structures and parameters is proposed. All the fault componentsof nodal voltage or branch current and the equivalent parameters of open port for each sequence net-work can be obtained rapidly. The method presented here is much more understandable in contrast tothose available, and meanwhile the amount of calculations is greatly reduced. Its effectiveness hasbeen verified by numerical examples.     

Analysis of the Power System''s Voltage Stabilization by Modeling and Simulink

The simulink of the power system can help people to analyze the actual power system's various state.As an important instrument,the Matlab software gains the recognition because of its all-sided and professional features.But when it is used in the field of dynamic process of the power system,there exist some disadvantages such as the difficulty of the modeling.The state-space module can be used to set up the three rank compact model of the generator and the electrical machine.It makes the modeling more convenient and more easily jointed to the system's primary parameter such as voltage and frequency.The typical model of the power system is built including the generator,electrical wire,load and SVC by using the function of the Simulink.In order to make the model's physical conception,some necessary predigestion is made to the typical model.At last,some conclusions about the voltage stabilization are gained by using the simulink of the system's malfunction,testifing the correctness and feasibility of this compact modeling.     

改进粒子群算法的自动阻抗匹配技术

由于无线电能传输距离的改变或谐振线圈之间发生偏移、负载改变等多方面的影响使系统的输入阻抗发生变化,导致输入阻抗与射频源内阻不匹配,使传输效率大幅下降。在射频源和发射线圈之间加入阻抗匹配网络可以提高无线电能的传输效率。为了提高阻抗匹配的精度和速度,提出了一种改进的粒子群算法。重点将改进算法和传统算法进行仿真实验比较,证明了改进算法在匹配精度和速度方面的优越性。最后将该算法嵌入到自动阻抗匹配系统中,提高了无线电能的传输效率,同时证明了所提算法的有效性。     

The on line monitoring method of power transmission line fault basednon linear frequency response function

A novel method for power transmission line monitoring and fault diagnosis is proposed based on non linear frequency response analysis. The power line carrier signal has been used for on line monitoring of power transmission line. As the non linear frequency response function describes the system inherent characterization, different frequency response patterns corresponding to different operation states of transmission line can be established. Based on the analysis of transmission line characteristics of fault modes, various fault features can be extracted, thereby achieve online monitoring and fault diagnosis on transmission line. Simulation experiments show the effectiveness of the proposed method.