首页 | 官方网站   微博 | 高级检索  
     

夏玉米机械粒收质量影响因素分析
引用本文:李璐璐,雷晓鹏,谢瑞芝,王克如,侯鹏,张凤路,李少昆.夏玉米机械粒收质量影响因素分析[J].中国农业科学,2017,50(11):2044-2051.
作者姓名:李璐璐  雷晓鹏  谢瑞芝  王克如  侯鹏  张凤路  李少昆
基金项目:国家自然科学基金(31371575)、国家玉米产业技术体系项目(CARS-02-25)
摘    要:【目的】机械粒收是玉米生产的发展方向,收获质量是影响其推广应用的主要因素。中国玉米机械粒收还处于起步阶段,目前在西北和东北等春播玉米区推广应用面积较大,黄淮海夏播玉米区正在积极开展试验示范。本研究通过分析黄淮海夏玉米机械粒收质量及其影响因素,为该技术的推广应用提供支持。【方法】2013—2015年累计选用了23个玉米品种,在黄淮海典型代表区河南新乡开展试验研究。2013年和2015年在收获期分别进行2次机械收获,2014年1次机械收获。收获当天测定各个品种的收获前籽粒含水率,并调查测产。机械收获后从机仓随机取一定量籽粒样品,立即测定收获后籽粒含水率,然后手工分拣样品,测定籽粒破碎率和杂质率;收获后,在田间选取3个代表性样区,调查落穗损失和落粒损失。【结果】2013—2015年,籽粒破碎率共调查131个样点,结果显示,收获时玉米籽粒含水率在20.80%—41.08%,籽粒破碎率变幅为4.98%—41.36%,籽粒破碎率随着籽粒含水率的提高明显升高;破碎率低于8%的有38个样点,占比29.01%,籽粒含水率低于26.92%时,收获的玉米籽粒能够满足破碎率8%以下的要求。机收杂质率共调查134个样点,杂质率0.37%—5.28%,杂质率低于3%的样点有107个,占比79.85%,杂质率也随着籽粒含水率的升高而增加;2013—2014年,籽粒含水率低于28.27%时,杂质率能够低于3%的国家标准;2015年收获时籽粒含水率虽然较高,但杂质率均在3%以下。田间损失率共调查108个样点,变幅为0.18%—2.85%(落穗率和落粒率),均能满足国家标准,损失率不是影响机械收获质量的限制因素。在本试验条件下,籽粒含水率低于26.92%时,破碎率和杂质率分别低于8%和3%,田间损失率也符合国家标准,能够满足机械粒收质量要求。研究还发现,籽粒含水率相近的不同品种之间,机械收获的破碎率和杂质率也存在显著差异,表明品种固有的理化特性对机械收获质量也有影响。【结论】收获时的籽粒含水率是影响机械粒收质量的关键因素,在相同籽粒含水率条件下,品种之间收获质量表现出显著差异。由于年际间热量等条件的不同,收获时的籽粒含水率存在一定幅度的变动,但通过选择适宜品种、科学安排播种和收获时间,以河南新乡为代表的黄淮海夏玉米区完全能够保证玉米机械粒收质量。

关 键 词:玉米  机械粒收  收获质量  籽粒含水率
收稿时间:2016-10-04

Analysis of Influential Factors on Mechanical Grain Harvest Quality of Summer Maize
LI LuLu,LEI XiaoPeng,XIE RuiZhi,WANG KeRu,HOU Peng,ZHANG FengLu,LI ShaoKun.Analysis of Influential Factors on Mechanical Grain Harvest Quality of Summer Maize[J].Scientia Agricultura Sinica,2017,50(11):2044-2051.
Authors:LI LuLu  LEI XiaoPeng  XIE RuiZhi  WANG KeRu  HOU Peng  ZHANG FengLu  LI ShaoKun
Affiliation:1.Institute of Crop Science, Chinese Academy of Agricultural Sciences/Key Laboratory of Crop Physiology and Ecology, Ministry of Agriculture, Beijing 100081;2.Hebei Agricultural University, Baoding 071000, Hebei
Abstract:【Objective】Mechanical grain harvest is the developing direction of maize production, and harvest quality is the main factor affecting its popularization and application. This harvest way in China is still in the preliminary stage. The application areas are larger in the Northwest and Northeast China while experimental demonstration is just actively carried out in Huang- Huai-Hai summer corn area. In this study, the influence factors on harvesting quality of mechanical grain harvest in summer maize were analyzed to provide supports for popularization and application of the technology. 【Method】From 2013 to 2015, twenty three different maize cultivars were planted in Xinxiang, Henan. Twice harvests were conducted in 2013 and 2015 and once in 2014. The moisture content and yield were measured before harvest. When mechanical harvest was finished, kernel samples were taken out from the harvester to investigate the moisture content immediately. Then, the grain broken rate and the impurity rate were measured in laboratory by hand-picked method. The ear and kernel loss rates were investigated in the field sample areas after harvest. 【Result】From 2013 to 2015, the results from 131 samples showed that corn kernel moisture content ranged from 20.80% to 41.08% and grain broken rate was between 4.98% and 41.36%. Grain broken rate increased with the rising grain moisture content. There were 38 samples that broken rate was below 8%, accounting for 29.01%. When kernel moisture content was under 26.92%, the broken rate could confirm to the standard of 8%. The results from 134 samples showed that the impurity rate was between 0.37% and 5.28%. There were 107 samples with impurity rate below 3% which accounted for 79.85%. The impurity rate also increased with the rising grain moisture content. From 2013 to 2014, the impurity rate did not meet the standard of 3% until grain moisture content was below 28.27% while the impurity rate was all below 3% with grain high moisture content in 2015. The loss rate from 108 samples ranged from 0.18% to 2.85% all of which confirmed to the national standard. Therefore, the loss rate didn’t limit the mechanical harvest quality. In this experiment, when kernel moisture content was lower than 26.92%, the broken rate and the impurity rate were below 8% and 3%, respectively, and the loss rate met the national standard simultaneously, which could ensure the quality of mechanical grain harvest. The study also found that there were significant differences in the broken rate and the impurity rate among different cultivars, representing the importance of proper cultivar. 【Conclusion】 Corn moisture content is the key factor for the quality of the grain mechanical harvest. Significant differences existed in harvest quality among cultivars when grain moisture contents were similar. Because of different growing conditions such as temperature between years, the grain moisture contents at harvest were different, but it is feasible for Huang-Huai-Hai summer maize region represented by Xinxiang, Henan to ensure the quality of grain mechanical harvest by choosing the adapted cultivars and adopting appropriate sowing and harvesting time.
Keywords:maize  grain mechanical harvest  harvest quality  grain moisture content
本文献已被 CNKI 等数据库收录!
点击此处可从《中国农业科学》浏览原始摘要信息
点击此处可从《中国农业科学》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号